Cannon 10 STX TS User Manual
9
www.cannondownriggers.com
FIGURE 5
FIGURE 6
FIGURE 7
FIGURE 8
6) Insert the 1/4-20 nylon locknut into the hex pocket on
the nose of the frame (motor side of frame). (Figure 5)
7) Insert 1/4-20 x 2” bolt into reel side of frame nose.
With a Phillips head screw driver, thread bolt into the
nylon locknut from step 6. Tighten bolt until the end of
the bolt is flush with the top of the nut. (Figure 6)
8) Slide ball hook collar to your preferred location. Hand
tighten the ball hook into boom tube. Tighten enough so
that there is no movement on the boom. (Figure 7)
Important: Do not overtighten ball hook or perma-
nent deformation of the boom is possible.
9) Once ball hook is secure, with a 7/16” wrench, tighten
the 1/4-20 nut until secure with ball hook collar.
(Figure 8)
**TELESCOPIC BOOM ONLY**
To adjust the boom length (with the boom extending
away from you) rotate the clamps (See item # 8 on page
5) approximately ¼ turn counter-clockwise to unlock and
slide the boom section to the desired position. Once in
place, lock the clamps by rotating clockwise until tight.
the nose of the frame (motor side of frame). (Figure 5)
7) Insert 1/4-20 x 2” bolt into reel side of frame nose.
With a Phillips head screw driver, thread bolt into the
nylon locknut from step 6. Tighten bolt until the end of
the bolt is flush with the top of the nut. (Figure 6)
8) Slide ball hook collar to your preferred location. Hand
tighten the ball hook into boom tube. Tighten enough so
that there is no movement on the boom. (Figure 7)
Important: Do not overtighten ball hook or perma-
nent deformation of the boom is possible.
9) Once ball hook is secure, with a 7/16” wrench, tighten
the 1/4-20 nut until secure with ball hook collar.
(Figure 8)
**TELESCOPIC BOOM ONLY**
To adjust the boom length (with the boom extending
away from you) rotate the clamps (See item # 8 on page
5) approximately ¼ turn counter-clockwise to unlock and
slide the boom section to the desired position. Once in
place, lock the clamps by rotating clockwise until tight.
Installation