LOEWE Individual 32 Compose 3D User Manual

133 -

All menus are displayed in the wrong 

 language.

The menu language was set incorrectly.  

Set the menu language:
Press the MEDIA button in TV mode. In the MediaPortal, 
highlight the last menu item (Index) in the upper half and 
call up with OK. Mark the first key word and call it with 

OK. Then select the language and confirm it with OK.

In the TV menu, Connections cannot be 
called (displayed in grey   ).

A timer recording is in progress.

Wait until the timer recording ends or delete the 
timer recording (page 125).

The control functions of the Loewe 
Recorder and the Timer are not working 
or are not working properly   

a) The Digital Link function is not activated or 

not possible in the recorder.

b) EURO-AV cable is not connected.

a) Activate Digital Link in the recorder (see operat-

ing instructions of the recorder).  

b) Connect EURO-AV cable (page 113).

General problems when connecting 

external devices via an AV input.

a) The AV standard is set incorrectly.
b) The signal type is set incorrectly.

a) Set the correct standard (page 110).
b) Set the correct signal type (page 110).
 If 

AV standard or AV signal is set to “Automatic” 

then this can cause errors to be detected with 
signals that do not comply with standards. In this 
case standard and signal must be set according to 

the information in the operating manual of the 
external device.

The connection of a decoder does not 
function or does not function properly.

a) The signal is not decoded because the correct 

decoder stations are not selected in the menu.

b) The sound is missing in decoder mode becau-

se the wrong decoder sound is assigned in the 
menu.

a) Select the right decoder stations in the menu (TV 

menu 

ט Connections ט Miscellaneous ט Decoder 

ט Select decoder station(s) (see page 111).

b) Select the right sound code (always, never, automa-

tic) in the menu (

TV menu 

ט  Connections  ט 

ט Decoder stations ט Sound encodig), 

see also decoder instructions.

Digital Link Plus does not work.

a) EURO-AV cable is not fully wired (pin 10 not 

wired).

b) Some recorders can only adopt stations 

during the initial installation of the TV set.  

a) Replace the EURO-AV cable.

b) Restore the recorder to the as-delivered state 

(see recorder’s operating manual).

With Teletext various characters are 
displayed incorrectly.

The wrong character set has been set in the 
Teletext menu.

Set the right character set: Select Teletext menu 

ט 

ט Character set ט Standard or the 

appropriate character set.

Errors occurred when running a CA 
module.

Switch the TV set off. Remove the CA-module from 
the TV set. Wait a few seconds. Reinsert the CA-
module. Switch the TV set on again.

Troubleshooting