Midland Radio PL5161 Series User Manual

Page of 58
9
Getting Started
Charging the NiMH Battery Pack
You will need to charge the battery pack fully before initial use. For best
results from your charging cycle, follow these tips:
•  Ensure the ambient temperature is between 41° and 104° F (5° and 40° C)
   while charging. Temperatures outside this range may not allow the radio to
   fully charge the battery.
•  Always switch OFF the transceiver equipped with a NiMH battery pack
   before charging. Using the radio during the charging cycle will hinder correct
   charging.
•  Do not recharge the battery pack if it is already fully charged. Doing so may
   cause the life of the battery pack to shorten or damage the battery pack.
•  If the battery is stored for 2 months or more to complete the charge
   discharge cycle two or three times to allow the battery capacity to return to
   normal.
•  Never dispose of the battery in fire - it can explode causing personal injury.
•  Never attempt to disassemble the battery or remove its case material or
   charging contacts. Do not short the battery terminals.
NOTE: The first few uses from the battery will not be at “normal” capacity.
After repeating the charge / discharge cycle two or three times, the battery
capacity will increase to provide full capacity.
Arbol de Menú de Opción del Sistema -
Configuración de la Búsqueda
(oprima MODE, a continuación oprima el botón
ascendente o descendente para la opción)
(oprima MODE, a continuación oprima el botón
ascendente o descendente para el menú deseado)
(oprima MODE, a continuación oprima el botón ascendente o
descendente para el submenú deseado: 4 selecciones)
(Oprima MODE para graduar la selección)
Para 
 oprima MODE, a continuación oprima el botón
ascendente o descendente para la selección)
* NOTA: Estas selecciones
no será visualizado, a menos
que se haya asignado un
canal de la prioridad
 (Oprima MODE para graduar la selección)
Para
 
 
oprima MODE, a continuación oprima el botón
ascendente o descendente para seleccionar el tiempo   
-- 
Para
 
 
oprima MODE, a continuación oprima el botón
ascendente o descendente para seleccionar el tiempo   
-- 
Para
 
 
oprima MODE, a continuación oprima el botón
ascendente o descendente para seleccionar el tiempo   
-- 
(Para las 3 graduaciones de arriba, oprima MODE para graduar la selección; use los
botones ascendente o descendente para seleccionar el tiempo; oprima MODE para
graduar el tiempo)
*
*
*
9 6