Kenwood TM-V708 User Manual

8 EchoLink

66

TM-D710A/E

3. Select “Menu” > “Transmit/Receive” from the Edit pulldown menu.  When using CTCSS or DCS 

for the purpose of preventing extraneous signals or noise from being fed into the Internet from a 
link station, configure “EchoLink RX Monitor” for “Busy Only” in the dropdown list.  When 
EchoLink Sysop mode is used, all signals received on the data band are output from the 
speaker regardless whether CTCSS or DCS has matched; whereas, only those signals that 
match CTCSS or DCS are output from the data terminal.

4. Select “Data Terminal” from the Edit pulldown menu.  Configure “SQC Output Logic” for “High” 

in the dropdown list so that a false Busy state is never detected, even when the transceiver is 
turned OFF.

Note: In the Sysop Setup window in EchoLink software, do not check the Invert Sense checkbox in the RX Ctrl tab.  

Refer to 8.5.2 Configuring EchoLink Software for a Link Station.

5. Select “Data Terminal” from the Edit pulldown menu.  If the audio level adjustment range on 

your computer is not sufficient, configure “PR1 Pin Output Level” to adjust the AF output level to 
the computer.  Also, configure “PKD Pin Input Level” to adjust AF input sensitivity that will vary 
the AF signal level fed into the transceiver.  These levels can be varied using steps of 
approximately 6 dB.