Kenwood TM-255A User Manual

8 EchoLink

TM-D710A/E

CONTENTS

Figure 8-43 Computer to TM-D710A/E Connections

1. Turn the power OFF.
2. Hold [PF2] down and turn the power ON.

Whenever Steps 1 and 2 are done, the EchoLink Sysop mode turns On and Off.

Note:

When EchoLink Sysop mode is On, the

icon appears.

When an audio signal is output from the data terminal to the personal computer, the

icon blinks.

When the personal computer has no RS-232C ports, then use a USB-to-serial conversion cable.

When EchoLink Sysop mode is On, the transceiver cannot communicate with MCP-2A Programming Software. Before
using MCP-2A, turn EchoLink Sysop mode Off.

8.5.4 Using MCP-2A to Configure TM-D710A/E

1. Select “Menu” > “Aux” from the Edit pulldown menu. Confirm “1200” bps is configured for “Data

Speed [bps]”. Data Speed can also be confirmed using Menu 518 on the transceiver.

2. Configure “SQC Output Source” for “SQL” in the dropdown list. This is the same as Menu 520

on the transceiver.

Figure 8-44 MCP-2A Aux Window: Data Speed and SQC Output Source

Internet

To PC audio terminal

Pink: To microphone input terminal
Green: To line out terminal

To PC 9-pin D-SUB terminal

PG-5H Cable Kit