Kenwood TK-8180 User Manual

TK-8180

r

CN2

u

t

E37-1113-05

y

The Horn alert (max. 2A drive), Public address and External

speaker function are enabled by installing the KAP-2 in the
TK-8180 transceiver.

1. Remove the cabinet, top packing and shielding plate of the

transceiver.

2. Set the KAP-2 relay unit jumper pins according to the pur-

pose of use.

3. Remove the 6-pin jumper connector inserted in the TX-RX

unit (B/3) connector (CN428). ( q )

4. Insert one side of the lead wire with connector (E37-1114-

05) into the relay unit connector (CN3) ( w ) and the other
side into the TX-RX unit (B/3) connector (CN428) ( e ).

CN428

q

CN428

CN3

E37-1114-05

w

e

5. Place the relay unit at the position shown in Figure 3-2 and

secure it to the chassis with a screw.

6. Remove the cap on the rear of the chassis by pushing it

from the inside with your finger. ( r )

7. Pass the 6-pin connector of the cable (E37-1113-05)

through the chassis hole ( t ) and insert the bush into the
chassis hole.

8. Rotate the bush of the cable 90 degrees counterclockwise

as viewed from the rear of the chassis. ( y )

9. Insert the 6-pin connector of the cable into the connector

(CN2) of the KAP-2 relay unit. ( u )

Note : You must setup using the KPG-89D.