Sennheiser LV308 User Manual

37

 SKP 100 G2 / SKP 500 G2 plug-on transmitters

Preparing for use

Inserting and changing the battery

For powering the plug-on transmitter, you can either use two 1.5 V
AA size batteries or the rechargeable Sennheiser BA 2015 accupack.



Slide the battery compartment cover 



 in the direction of the

embossed arrow until it clicks audibly and open the cover.



Insert the two batteries or the BA 2015 rechargeable battery as
shown below. Please observe correct polarity when inserting the
batteries/accupack.



Close the battery compartment. The battery compartment cover
9 locks into place with an audible click.

Note:

For rechargeable battery operation of the transmitter, only use
the BA 2015 rechargeable battery in order to ensure optimum
operational reliability. For charging the accupack, only use the L
2015 charger. Both the rechargeable battery and the charger are
available as accessories.
The rechargeable battery is fitted with an integrated sensor
which is – via a third contact – monitored by the electronics of
the plug-on transmitter and the charger. The sensor is necessary
for the following control purposes:

y

The taking into account of the different voltage characteristics
of primary cells (batteries) and accupacks. The battery status
indications on the displays, the transmission of transmitter
battery status information to the rack-mount receivers and
the switch-off thresholds at the end of the operating time are
corrected correspondingly. Due to the missing sensor,
individual rechargeable battery cells will not be identified as
accupacks.

y

The monitoring of the rechargeable battery temperature
during charing in the L 2015 charger.

Plugging the transmitter onto the microphone 



Plug the transmitter’s XLR-3 connector 



 onto the microphone’s

XLR-3 socket.



Tighten the locking ring 



.

Note:

The transmitter uses the microphone body as an antenna –
therefore only microphones with a metal casing should be used
for best signal transmission.