Sharp LC 20DV20U User Manual

You can change channels in several ways. 

Simple operations for watching a TV program

POWER indicator

Press POWER on the TV/DVD, or POWER on the 

remote control.

•  POWER indicator (Green): The TV/DVD is on. 

•  The LANGUAGE setup menu will appear automatically 

when TV MENU is pressed on for the fi rst time. 

Press POWER on the TV/DVD, or POWER on the 

remote control.

•  The TV enters standby mode and the image on the 

screen disappears.

•  The POWER indicator on the TV/DVD changes to Red.

•  If you are not going to use this TV/DVD for a long period 

of time, be sure to remove the AC cord from the power 

outlet.

•  Weak electric power is still consumed even when 

POWER is turned off.

•  If a station being viewed stops broadcasting, the TV will 

automatically shut itself off after 15 minutes.

Perform the following steps before you press POWER 

on the remote control unit.

1.  Insert the batteries into the remote control unit. 
 

(See page 8.)

2.  Connect the antenna cable to the TV/DVD. (See page 

12.)

3.  Plug in the AC cord to the AC outlet. (See page 7.)

POWER

ON

Lighting (Green)

Lighting (Red)

OFF/Standby

Press 1J1J5

•  When selecting a 1-digit channel number, it is not 

necessary to press 0  before the number.

•  If you push “0” by itself, nothing will happen.

•  Complete the above steps within a few seconds.

Method 1
Using CH 

/

 on the remote control unit or on the 

TV/DVD.
Method 2
Using remote control buttons 0

9 to select channels 

for VHF/UHF/CATV.

Press 5

VOLUME 25 

Changing the volume
You can change the volume on the TV/DVD or on the 

remote control unit.

•  VOL+/– on the TV/DVD operates the same as VOL+/– 

  on the remote control unit.

Using VOL +/–

•  To increase the volume, press 

.

•  To decrease the volume, press 

.

MENU VOL +/– CH 

/

Press TV/DVD to select the TV mode.

5X20431A_P01-15.indd   13

5X20431A_P01-15.indd   13

5/19/2006   10:51:32 PM

5/19/2006   10:51:32 PM