Siemens 410 User Manual
4 Using the MICROMASTER 410
Issue A1
MICROMASTER 410 Operating Instructions
48
6SE6400-5EA00-0BP0
4.4 Control
Modes
(P1300)
The various modes of operation of the MICROMASTER 410 control the relation-
ship between the speed of the motor and the voltage supplied by the inverter. A
summary of the control modes available are listed below:
ship between the speed of the motor and the voltage supplied by the inverter. A
summary of the control modes available are listed below:
Ø Linear V/f control,
P1300 = 0
Can be used for variable and constant torque applications, such as conveyors
and positive displacement pumps.
and positive displacement pumps.
Ø Linear V/f control with FCC (Flux Current Control),
P1300 = 1
This control mode can be used to improve the efficiency and dynamic
response of the motor.
response of the motor.
Ø Quadratic V/f control
P1300 = 2
This mode can be used for variable torque loads, such as fans and pumps.
Ø Multi-point V/f control
P1300 = 3
For information regarding this mode of operation, please consult the MM410
Parameter List.
Parameter List.
4.5 Faults
and
Alarms
Standard Inverter
If an Operator Panel is not fitted, the fault states and warnings are indicated by the
LED on the panel, see section 6.1 on page 57 for further information.
LED on the panel, see section 6.1 on page 57 for further information.
If the inverter is working correctly, the following LED sequence is visible:
Ø Flashing Yellow (1000 ms on / 1000 ms off) =
Ø Flashing Yellow (1000 ms on / 1000 ms off) =
Ready to run
Ø Continuous
Yellow
= Run
Operator Panel Fitted
If an Operator Panel is fitted, the fault states (P0947) and warnings (P2110) are
displayed should a fault condition occur. For further details, please refer to the
Parameter List.
displayed should a fault condition occur. For further details, please refer to the
Parameter List.