Leica DM1000 LED User Manual
57
14. Retrofitting Components
14.1
Equipping the Condenser Disk*
• Turn the stage upwards and lower the
condenser
• Remove the condenser by loosening the
condenser’s clamping screw
Condenser UCL/UCLP*
• Loosen the screw (55.1) completely
• Turn back the centering screws until the light
rings*,
λ - and λ/4 - compensator* and lens*
2.5x can be inserted;
the largest hole is for brightfield
observation (= BF), the slightly smaller ones
are for light rings, λ - and λ/4 - compensator
or lens* 2.5x
the largest hole is for brightfield
observation (= BF), the slightly smaller ones
are for light rings, λ - and λ/4 - compensator
or lens* 2.5x
Fig. 55
Condenser UCL
1
Fixing screw for condenser disk
1
14. Retrofitting Components
Notes:
If you use a smaller hole for brightfield, the
maximum illumination aperture cannot be used.
maximum illumination aperture cannot be used.
The lettering (e.g. DF, PH 1 ....., λ) must point
upward, the λ
upward, the λ
or λ/4 compensators must be
inserted with the correct orientation: The notch
must point towards the center of the disk! The
lettering of the components should correspond
to the marking at the opposite position (outer
edge of the disk).
must point towards the center of the disk! The
lettering of the components should correspond
to the marking at the opposite position (outer
edge of the disk).
• Tighten the centering screws until the
components are roughly in the center of the
holes
holes
Fig. 56
UCL condenser disk
1
Condenser disk
2
Light ring or
λ− or
λ
/
4-compensator
3
Centering screws
4
Axis
5
Centering keys
6
λ- orλ/4-plate
7
Auxiliary lens