IMC Networks 9830 User Manual
2
Installing the IE–ModeConverter
The IE–ModeConverter installs anywhere as a standalone, table-top device or on a
DIN rail.
DIN rail.
As a standalone device, install it in locations with limited space.
If multiple connections are required, use an IE-PowerTray/18 enclosure, (sold
separately). The tray allows for 18 conversions in a 1.5 rack unit of space. The units
can also be powered by daisy-chaining DC power (refer to Cascading DC Power).
separately). The tray allows for 18 conversions in a 1.5 rack unit of space. The units
can also be powered by daisy-chaining DC power (refer to Cascading DC Power).
SFP Port Requirements
The IE–ModeConverter requires two SFP Modules of the same speed, either two fast
Ethernet (100Mbps) modules or two Gigabit Ethernet (1000Mbps) modules.
Ethernet (100Mbps) modules or two Gigabit Ethernet (1000Mbps) modules.
NOTE
Both SFPs must operate at the same speed.
DIN Rail Mounting
The IE–ModeConverter can be mounted
with two DIN Rail clips, a hardware
option available through IMC Networks.
The DIN Rail clips include screws, to
allow the installation onto a DIN Rail.
Install the screws into DIN Rail clips,
which should be mounted perpendicular
to the DIN Rail. Snap the converter onto
the clips. To remove the converter from
the DIN Rail, use a flat-head screwdriver
into the slot to gently pry the converter
from the rail.
with two DIN Rail clips, a hardware
option available through IMC Networks.
The DIN Rail clips include screws, to
allow the installation onto a DIN Rail.
Install the screws into DIN Rail clips,
which should be mounted perpendicular
to the DIN Rail. Snap the converter onto
the clips. To remove the converter from
the DIN Rail, use a flat-head screwdriver
into the slot to gently pry the converter
from the rail.
NOTE
The DIN clips are designed for use on a DIN-35 rail.