Pelco C1487M-D User Manual

8

Pelco Manual C1487M-D (7/99)

BB5T-PB

Black pendant-mount back box (CE, UL, cUL)

BB5T-PG

Light gray pendant-mount back box (CE, UL, cUL)

BB5T-PG-E

Same as BB5T-PG except includes heater and sun shield (CE, UL, cUL)

DD5TAC

Dome drive with color camera and lens, NTSC standard (FCC, UL, cUL)

DD5TAC-X

Dome drive with color camera and lens, PAL standard (CE)

LD5PB-0

Smoked lower dome (1/2 f-stop of light loss) for black pendant-mount dome

LD5PB-1

Clear lower dome for black pendant-mount dome

LD5PB-2

Chrome lower dome (2 f-stops of light loss) for black pendant-mount dome

LD5PB-3

Gold lower dome (2 f-stops of light loss) for black pendant-mount dome

LD5PG-0

Smoked lower dome (1/2 f-stop of light loss) for light gray pendant-mount dome

LD5PG-1

Clear lower dome for light gray pendant-mount dome

LD5PG-2

Chrome lower dome (2 f-stops of light loss) for light gray pendant-mount dome

LD5PG-3

Gold lower dome (2 f-stops of light loss) for light gray pendant-mount dome

LD5PG-E0

Same as LD5PG-0 except includes heater

LD5PG-E1

Same as LD5PG-1 except includes heater

BB5T-F

Indoor back box for flush mounting in a ceiling (CE, UL, cUL)

DD5TAC

Dome drive with color camera and lens, NTSC standard (FCC, UL, cUL)

DD5TAC-X

Dome drive with color camera and lens, PAL standard (CE)

LD5F-0

Smoked lower dome (1/2 f-stop of light loss)

LD5F-1

Clear lower dome

LD5F-2

Chrome lower dome (2 f-stops of light loss)

LD5F-3

Gold lower dome (2 f-stops of light loss)

To install the dome proceed through the steps in this section, beginning with the 

Ceiling and

Back Box Preparation

 section.

1.

Locate the center point where you want to drill a hole in the ceiling. (The ceiling tile
cannot be thinner than 0.50 inch [1.27 cm] nor thicker than 1.75 inches [4.45 cm].)

2.

Drill a hole in the ceiling using a 3/32-inch drill bit.

3.

Remove the compass tool from the parts bag that came with the back box (refer to
Figure 4). Press the stud of the compass tool into the hole in the ceiling. Insert a pencil
in the hole in the other end of the compass and mark a circle on the ceiling.

4.

Carefully cut the circle out of the ceiling.

5.

Remove the conduit fitting, lock nut, and safety chain bracket from the parts bag and
attach them to the back box as shown in Figure 5.

Proceed to the 

Wiring 

section.

ATTACH SAFETY CHAIN HERE

Be

careful not to cut
outside of the line.

If you do, you may not be
able to install the back box.
Also, the trim ring may not
cover the hole.

Use the SCA1

(structural ceiling adapter) if
additional support is required.

Figure 4.  Compass Tool

Figure 5.  Conduit Fitting Installation