User ManualTable of ContentsFront1Document printing history3Important safety information4Warranty information5Contents7Preface9Who is this manual for?9Who to call for assistance9CHAPTER 1: Introduction11CHAPTER 2: Setting up your hardware13Taking inventory13The 1010 package contains the following items:13One 1010 unit13One RJ11 to RJ45 cable13One RJ45 to RJ45 cable13One power supply unit (AD62010)13One plastic wall mount bracket13Two jumpers13Two screws and two plastic anchors for wall mounting13User’s Guide13One warranty card13Front panel LEDs13There are three (3) LEDs on the front panel of the 1010.13Figure 2— 1010 NT1 front panel13Power LED13When the 1010 is plugged into the wall outlet, the POWER LED will be on.13S/T&U LED14The S/T&U LED will flash for a few seconds when the 1010 is first powered on. This LED will then ...14a If there is no ISDN line connected to the U-interface or the line is not activated, then the S/...14b If the U-interface is detected, but is not in sync., the S/T&U LED will flash eight times per s...14c If the U-interface is in sync., but the S/T-interface is not, then the S/T&U LED will flash onc...14d Once both the S/T- and U-interfaces are in sync., the S/T&U LED will go off.14Loopback LED14The U LOOP BACK LED will light only during a telephone company full "2B+D" loopback test. The ISD...14CHAPTER 3: Installing your unit15Rear panel15Power connector16DIP switch setting16Internal jumper settings17Wiring instructions18Wall mounting instructions19Power source19CHAPTER 4: S/T bus configuration21CHAPTER 5: Specifications23FCC compliance information24Size: 188 KBPages: 24Language: EnglishOpen manual