User ManualTable of ContentsBEFORE YOU BEGIN...................................................................................…. 12IMPORTANT SAFETY NOTICES..................................................................…. 22HARDWARE IDENTIFIER.....…....................................................................…. 32ASSEMBLY INSTRUCTIONS........................................................................…. 42EXPLODED DIAGRAM………………………………………………………………. 102PARTS LIST...............................................................................................……. 112WARRANTY.................................................................................................…. 122ORDERING PARTS.......................................................................................… 122ASSEMBLY INSTRUCTION5Attach the bottom of Right Upright Beam (#3) to the Rear Stabilizer (#5). Attach the Right Upright Beam to the Cross Brace (#7).7Secure the Right Upright Beam to the Rear Stabilizer with two M10 x 3 1/8” Carriage Bolts (#54), ( ¾” Washers (#64), and M10 Aircraft Nuts (#63).7Secure the Right Upright Beam to the Cross Brace with two M10 x 2 ¾” Carriage Bolts (#56), one 4 ¾” x 2” Bracket (#27), two ( ¾” Washers (#64), and two M10 Aircraft Nuts (#63).7Repeat Steps A, B, and C above to install the Left Upright Beam (#2).7Insert the Left & Right Bar Holders (#23 & 24) into the selected holes on the Upright Beam.7Attach the Cable (#17) to the opening on the top of the Lat Bar Frame (#1). Make sure the ball stopper of the Cable is underneath the Frame.8Attach a Pulley (#29) to the opening. Secure it with one M10 x 2 ½” Allen Bolt (#57), two Ø 5/8” Pulley Bushings (#43), two ( ¾” Washers (#64), and one M10 Aircraft Nut (#63).8Draw the Cable to the bracket on the top of Lat Bar Frame. Attach a Pulley to the bracket. Secure it with one M10 x 2” Allen Bolt (#55), one L-shaped Pulley Bracket (#28), two ( ¾” Washers (#64), and one M10 Aircraft Nut (#63).8Pull the Cable down to the Sliding Weight Post (#11). Secure the Cable to the Post with one M10 x 1 3/8” Allen Bolt (#53), two ( ¾” Washers (#64), and one M10 Aircraft Nut (#63).8Connect a Chain (#37) to the Lat Bar (#12) with a C-clip (#36). Connect the Chain to the Cable with another C-clip.8Attach the Seat Support (#15) to the bracket on the Main Frame. Secure it with one M10 x 2 ½” Allen Bolt (#57), two ( ¾” Washers (#64), and one M10 Aircraft Nut (#63).9Attach the holes on the Backrest Supports (#16) to the pivot on the Seat Support (#15). Attach the Backrest Board (#19) to the Backrest Supports (#16). Secure it with four M6 x 1 3/8” Hex Bolts (#58) and ( ½” Washers (#66).9Place the Seat (#18) onto the Seat Support (#15). Secure it with four M6 x 5/8” Hex Bolts (#60) and ( ½” Washers (#66). Insert a L-shaped Pin (#40) into the hole on the Seat Support to lock the Seat and Backrest Board in position. Remove the Pin when f9Attach the Arm Curl Pad (#20) to the Arm Curl Stand (#9). Secure it with two M8 x 5/8” Hex Bolts (#61) and ( 5/8” Washers (#65).9Insert the Arm Curl Stand into the opening on the Main Frame. Secure it with a M10 Lock Knob (#33).9DIAGRAM 59PARTS LIST12KEY NO. DESCRIPTION Q’ty12Size: 1.99 MBPages: 13Language: EnglishOpen manual