User ManualTable of ContentsTable of Contents2Features3Ratings4Block Diagram4Model and Ordering Information5Model5Description5Comments5WiFiHU2-a5WiFi USB Module with dual on board chip antennae5Uses onboard chip antennae. Not for use with External Antenna. Allows designer to determine USB Jack placement.5WiFiHU2-a-1-NE5WiFiHU2-a installed in a WiFiHU2-CB1 Carrier Board with on board USB Jack.5Complete WiFi Module with dual chip antennae with USB Jack interface.5WiFiHU2-c *5WiFi USB Module with two SMD Connectors for attaching antenna cables and 2.4GHz 2 dBi Omni-directional antennas5Allows designer to determine USB Jack and antenna placement. Can use one or two cables and antennas5WiFiHU2-c-1-NE*5WiFiHU2-c installed in WiFiHU2-CB1 Carrier Board with on board USB Jack.5Complete WiFi Module for 2 cables and 2 antennas with USB Jack interface.5*These models can use either one or two cables and antennas. For ultimate performance, we recommend using two antennas to meet MIMO requirement with better adaptability for receiving.5WiMDK-20016WiMDK-2001-a Kit for6Model WiFiHU2-a-1-NE6WiMDK-2001-c Kit for Model WiFiHU2-c-1-NE6AC6i-RP-SMA66" U.FL. to RP-SMA female connector antenna cable6Antenna Cable for models WiFiHU2-c and WiFiHU2-c-1-NE6ATN-2d-RP-SMA6Replacement antenna, 2.4GHz, 2dBi, RP-SMA, Omni-directional.6Antenna for models WiFiHU2-c and WiFiHU2-c-1-NE6Connecting the WiFiHU2 or WiFiHU2-NE to Your System7Mechanical Specification and Pin Orientation for the WiFiHU28Mechanical Specification for the9WiFiHU2-c-1-NE and WiFiHU2-a-1-NE9WiFiHU2 USB Interface Pins10Additional Information on the Interface Signals11Important Regulatory Compliance and User Information13FCC RF Radiation Exposure Statement15IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, the antenna used on this transmitter must be installed to provide a separation of at least 20 cm from all persons and must not be co-located or operating in conjunction with any antenna or transmitter. This device contains a low power transmitter. When this device is operational, use only with the supplied, or recommended antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC regulations. Changes or modifications not expressly approved by the manufacturer or party responsible for compliance could void the user’s authority to operate the equipment.15FCC Interference Statement15This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:15(1) This device may not cause harmful interference15(2) This device must accept any interference received, including interference15that may cause undesired operation.15This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.15This equipment generates and radiates radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:15● Reorient or relocate the receiving antenna.15● Increase the separation between the equipment and receiver.15● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.15● Consult the dealer or an experienced radio/TV technician for assistance.15IC (Industry Canada) Statement15This product meets the applicable Industry Canada technical specifications. / Le present materiel est conforme aux specifications techniques applicables d’Industrie Canada.15Europe – R&TTE Compliance Statement:15Hereby, Radicom Research Inc., declares that this equipment complies with the essential requirements and other relevant provisions of DIRECTIVE 1999/5/CE OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of March 9, 1999 on radio equipment and telecommunication terminal Equipment and the mutual recognition of their conformity (R&TTE).15CE Declaration of Conformity16For the following equipment:16is herewith confirmed to comply with the requirements set out in the Council (European parliament) Directive on the Approximation of the Laws of the16Member States relating to Electromagnetic Compatibility of Radio and Telecom device (1999/5/CE). For the evaluation regarding this Directive, the following16standards were applied:16EN 61000-3-2:2006+A2:2009, EN 300 328 V1.7.1, EN 62311: 2008,16EN 301 489-1, V1.8.1, EN 61000-3-3:2008, EN 301 489-17 V2.1.116________________________16This equipment is marked with the and can be used throughout the European community.16France – 2.4GHz for Metropolitan France:16In all Metropolitan departments, wireless LAN frequencies can be used under the following conditions, either for public or private use:16 Indoor use: maximum power (EIRP*) of 100 mW for the entire 2400-2483.5 MHz frequency band16Driver Installation Guide For Windows XP18WiFiHU2 USB Linux Driver Quick Installation Guide20Limited Warranty21Warranty Coverage and Duration21Contacting Radicom Research23http://www.radi.com/23Size: 584 KBPages: 24Language: EnglishOpen manual