User ManualTable of ContentsProduct Information1Installation Guidelines1Materials Needed1Verify Programming and Sensor-to-Panel RF Communication11. Put panel/receiver into sensor test mode.12. Take sensor to desired mounting location.13. Trip the sensor. The sensor transmits a test signal.14. Listen for siren beeps to determine appropriate response (refer to the panel/receiver Installation Instructions).15. Exit sensor test mode.11. Remove the sensor cover by pressing a small screw driver into the slot on the end of the sensor while lifting the cover.1Figure 1. Opening the Sensor Cover12. Mount the sensor base with two #6 flathead screws at the locations shown in Figure 2.1Figure 2. Mounting the Sensor and Magnet13. Remove the magnet from its base. Line up the arrow on the magnet with the mark on the narrow end or side of the sensor.14. Mount the magnet base no more than 1 cm away from the sensor base. Replace the magnet cover.15. Install the tamper switch as shown in Figure 316. Attach the sensor cover to the sensor base1Figure 3. Installing Tamper Switch1Connecting External Switches2Figure 4. External Switch Terminal2Materials and Tools Needed2Installation Guidelines21. Install the magnet on the opening edge of the door or movable part of a window.22. Position the switch on the door or window frame within 2.5 cm of the magnet.23. Install a 4.7 k ohm EOL resistor in series with the exter nal switch at the switch location, not at the sensor.24. Remove the sensor cover.25. Pass the wires on the external switch through the rear opening at the bottom of the sensor.26. Attach each wire to one side of the screw terminal. Use no more than 3 meters of wire.27. Press the screw terminal over the wire posts.28. Mount the sensor.2Programming21. Set the panel to program mode.22. Proceed to the LEARN SENSORS menu.23. Trip the sensor tamper switch by removing the sensor cover.24. Select the appropriate sensor group and sensor number assignments.25. Exit program mode.2Sensor Test21. Put panel/receiver into sensor test mode (see panel/ receiver installation instructions).22. Open the door the sensor is protecting. The sensor transmits a test signal.23. Listen for siren beeps to determine appropriate response (refer to the panel/receiver Installation Instructions).24. Close panel cover.2Specifications2Notices2900 MHz Door/Window Sensor1PRELIMINARY 10/29/031Size: 405 KBPages: 2Language: EnglishOpen manual