Crestron electronic DM-CBL-P Prospecto
Characteristic Impedance: 100 ohms ±15% (0.772 to 100 MHz);
Velocity of Propagation: 70%;
Conductor DC Resistance: 28.6 ohms / 1000 ft maximum;
DC Resistance Unbalance: 3% maximum
Velocity of Propagation: 70%;
Conductor DC Resistance: 28.6 ohms / 1000 ft maximum;
DC Resistance Unbalance: 3% maximum
JJa
acckke
ett:: Color: Yellow;
Material: Low-smoke PVC;
Ripcord: yes;
Thickness: 0.018 inch;
Outer Diameter: 0.185 inch nominal
Ripcord: yes;
Thickness: 0.018 inch;
Outer Diameter: 0.185 inch nominal
‘DMNet’ Control & Power
C
Co
on
nssttrru
uccttiio
on
n:: (1) 22 AWG shielded pair (control) and (1) 18 AWG pair
(power) w/overall jacket
C
Co
on
nttrro
oll P
Pa
aiirr:: Colors: Gray/orange;
Conductors: 22 AWG x2 stranded copper;
Insulation: 0.025 inch thick foam FEP;
Shield: Aluminum/Polyester (100% coverage) w/aluminum on the inside;
Drain: 24 AWG tinned stranded copper;
Capacitance: 12.5 pF / ft, nominal;
Impedance: 100 ohms, nominal
Insulation: 0.025 inch thick foam FEP;
Shield: Aluminum/Polyester (100% coverage) w/aluminum on the inside;
Drain: 24 AWG tinned stranded copper;
Capacitance: 12.5 pF / ft, nominal;
Impedance: 100 ohms, nominal
P
Po
ow
we
err P
Pa
aiirr:: Colors: Red/black;
Conductors: 18 AWG x2 stranded copper;
Insulation: 0.01 inch thick low-smoke PVC;
Shield: none
Insulation: 0.01 inch thick low-smoke PVC;
Shield: none
JJa
acckke
ett:: Color: Gray;
Material: Low-smoke PVC;
Ripcord: yes;
Thickness: 0.0325 inch;
Outer Diameter: 0.25 inch nominal
Ripcord: yes;
Thickness: 0.0325 inch;
Outer Diameter: 0.25 inch nominal
Outer Jacket
C
Co
om
mp
po
ossiitte
e C
Co
on
nssttrru
uccttiio
on
n:: All wires contained in a Mylar wrap w/overall outer jacket
M
Ma
atte
erriia
all:: Low-smoke PVC, flexible
R
Riip
pcco
orrd
d:: yes
T
Th
hiicckkn
ne
essss:: 0.03 inch
O
Ou
utte
err D
Diia
am
me
ette
err:: 0.58 inch (14.73 mm) nominal
C
Co
ollo
orr:: Blue w/red stripe
Rating
NEC Article 800; UL Subject 444, Type CMP; CSA Type CMP
AVAILABLE ACCESSORIES
D
DM
M--C
CO
ON
NN
N
DigitalMedia
™
Cable Connector
* The maximum allowable cable length depends on multiple factors. One or more
DM Repeaters (Model DM-DR) may be required. Refer to the Crestron DigitalMedia
Design Guide, Doc. #4789 for complete wiring guidelines.
Design Guide, Doc. #4789 for complete wiring guidelines.
C
Crre
essttrro
on
n D
DM
M--C
CB
BL
L--P
P
Crestron DM-CBL-P cable provides a high-performance, single-cable wiring
solution for DigitalMedia (DM) systems in a commercial plenum application.
Within a single plenum-rated jacket, DM-CBL-P contains one high-bandwidth/
low-crosstalk shielded 4-twisted pair (STP) cable, one CAT5e unshielded 4-twisted
pair (UTP) cable, and one DMNet cable.
solution for DigitalMedia (DM) systems in a commercial plenum application.
Within a single plenum-rated jacket, DM-CBL-P contains one high-bandwidth/
low-crosstalk shielded 4-twisted pair (STP) cable, one CAT5e unshielded 4-twisted
pair (UTP) cable, and one DMNet cable.
The STP "Video Data" cable, which connects to the 'D' port of a DigitalMedia device,
is of a specialized construction designed to allow the longest possible cable
lengths* for transporting high-definition digital video and audio. The Cat5e
“Data Management" cable, which connects to the 'M' port, carries high-speed
Ethernet and other data, plus 5V DC power. Finally, the DMNet cable carries
additional proprietary control signals and 24V DC power.
is of a specialized construction designed to allow the longest possible cable
lengths* for transporting high-definition digital video and audio. The Cat5e
“Data Management" cable, which connects to the 'M' port, carries high-speed
Ethernet and other data, plus 5V DC power. Finally, the DMNet cable carries
additional proprietary control signals and 24V DC power.
Wiring a DigitalMedia system using DM-CBL-P is simple, requiring just one cable
to be run to each DM receiver (i.e. Room Controller) and transmitter location*.
Foot markers are printed on the outer jacket making it easy to determine the
exact length of each cable run when commissioning the installed system.
to be run to each DM receiver (i.e. Room Controller) and transmitter location*.
Foot markers are printed on the outer jacket making it easy to determine the
exact length of each cable run when commissioning the installed system.
Termination of a DM cable is accomplished using one standard RJ45 (not
provided) for 'M', one detachable terminal block (provided with each DM device)
for DMNet, and one Crestron DM-CONN shielded RJ45 (sold separately) for ‘D’.
The DM-CONN connector enables fast and reliable termination of the shielded
twisted-pair cable without requiring any special tools.
provided) for 'M', one detachable terminal block (provided with each DM device)
for DMNet, and one Crestron DM-CONN shielded RJ45 (sold separately) for ‘D’.
The DM-CONN connector enables fast and reliable termination of the shielded
twisted-pair cable without requiring any special tools.
For non-plenum applications, use DM-CBL-NP.
AVAILABLE MODELS
D
DM
M--C
CB
BL
L--P
P--S
SP
P5
50
00
0
DigitalMedia
™
Cable, plenum, 500 ft spool
SPECIFICATIONS
‘D’ Video Data
C
Co
on
nssttrru
uccttiio
on
n:: Four twisted pair, each pair isolated by an internal spline within an inner jacket,
shield, braid, and overall jacket
((4
4)) T
Tw
wiisstte
ed
d P
Pa
aiirrss:: Colors: Blue/white, orange/white, green/white, brown/white;
Conductors: 24 AWG x8 solid copper;
Insulation: 0.0055 inch thick FEP;
Outer Diameter (per conductor): 1.028 ±0.02 mm;
Shield: Aluminum/Mylar tape w/aluminum on the outside;
Braid: Tin/copper (45% coverage);
Mutual Capacitance: 5600 pF / 100 m;
Capacitance Unbalance: 330 pF / 100 m;
Characteristic Impedance: 100 ohms ±15% (1-250 MHz)
Insulation: 0.0055 inch thick FEP;
Outer Diameter (per conductor): 1.028 ±0.02 mm;
Shield: Aluminum/Mylar tape w/aluminum on the outside;
Braid: Tin/copper (45% coverage);
Mutual Capacitance: 5600 pF / 100 m;
Capacitance Unbalance: 330 pF / 100 m;
Characteristic Impedance: 100 ohms ±15% (1-250 MHz)
IIn
nn
ne
err JJa
acckke
ett:: Color: Natural;
Material: Low-smoke PVC;
Thickness: 0.015 inch
Thickness: 0.015 inch
JJa
acckke
ett:: Color: Blue;
Material: Low-smoke PVC;
Thickness: 0.018 inch;
Outer Diameter: 7.62 ±0.38 mm
Thickness: 0.018 inch;
Outer Diameter: 7.62 ±0.38 mm
‘M’ Data Management (CAT5E)
((4
4)) T
Tw
wiisstte
ed
d P
Pa
aiirrss:: Colors: Blue/white, orange/white, green/white, brown/white;
Conductors: 24 AWG x8 solid copper;
Insulation: 0.0077 inch thick FEP;
Shield: none;
Mutual Capacitance: 14 pF / ft nominal;
Capacitance Unbalance: 330 pF / 100 m maximum;
Insulation: 0.0077 inch thick FEP;
Shield: none;
Mutual Capacitance: 14 pF / ft nominal;
Capacitance Unbalance: 330 pF / 100 m maximum;
www.crestron.com
|
800.237.2041
Crestron Electronics, Inc. 15 Volvo Drive
l
Rockleigh, NJ 07647
Tel: 800.237.2041 / 201.767.3400
l
Fax: 201.767.1903
DigitalMedia
™
Cable, plenum
Specifications subject to change without notice. Doc.4763 01/09
©2009 Crestron Electronics, Inc. All brand names, product names and trademarks are the property of their respective owners.