Graco 3A2096D Manual De Usuario
Connect
Connect
Connect the
the
the Power
Power
Power Supply
Supply
Supply
Improper wiring may cause electric shock or other
serious injury if work is not performed properly.
Have a qualified electrician perform any electrical
work. Be sure your installation complies with all
National, State and Local safety and fire codes.
serious injury if work is not performed properly.
Have a qualified electrician perform any electrical
work. Be sure your installation complies with all
National, State and Local safety and fire codes.
1.
Ensure that the fused safety switch (B, Fig 2) is
shut off and locked out.
shut off and locked out.
Figure 2 Locked Out Fused Safety Switch
2.
See Fig. 3. Install a start/stop control (C) in the
electrical supply line (A), within easy reach of
the equipment. The start/stop control must be
approved for use in hazardous locations.
electrical supply line (A), within easy reach of
the equipment. The start/stop control must be
approved for use in hazardous locations.
3.
Open the electrical compartment (S) on the
motor.
motor.
4.
Bring the power wires into the electrical
compartment through the 3/4–14 npt(f) inlet port.
Connect the wires to the terminals, as shown.
Torque the terminal nuts to 25 in-lb (2.8 N•m)
maximum. Do
compartment through the 3/4–14 npt(f) inlet port.
Connect the wires to the terminals, as shown.
Torque the terminal nuts to 25 in-lb (2.8 N•m)
maximum. Do
Do
Do not
not
not over-torque.
over-torque.
over-torque.
5.
Close the electrical compartment. Torque the
cover screws to 15 ft-lb (20.3 N•m).
cover screws to 15 ft-lb (20.3 N•m).
Figure 3 Connect the Power Wires
Notes
Notes
Notes for
for
for Fig.
Fig.
Fig. 3
3
3
Tighten all terminal nuts to 25 in-lb (2.8 N•m)
maximum. Do
maximum. Do
Do
Do not
not
not over
over
over---torque.
torque.
torque.
Tighten cover screws to 15 ft-lb (20.3 N•m).
A conduit seal (D) is required within 18
in. (457 mm) of the motor for the US and
Canada.
in. (457 mm) of the motor for the US and
Canada.
10
3A2096D