Dimension One Spas 2003 Manual De Usuario
Aquatic Fitness System
2003 Owner’s Manual
Temperature Set Buttons
Temperature Set Buttons: Press the “Warmer” Up Arrow button to increase the
desired temperature. Press the “Cooler” Down Arrow button to decrease the
temperature. The temperature set point can be adjusted in 1°F increments from 65°F
to 104°F (18.3°C to 40°). The new setting will remain on the display for 5 seconds as
a confirmation.
desired temperature. Press the “Cooler” Down Arrow button to decrease the
temperature. The temperature set point can be adjusted in 1°F increments from 65°F
to 104°F (18.3°C to 40°). The new setting will remain on the display for 5 seconds as
a confirmation.
This new temperature setting is referred to as the “set temperature”
setting throughout this document. It refers to the water temperature
that you want the system to maintain for you (e.g. 96°F).
setting throughout this document. It refers to the water temperature
that you want the system to maintain for you (e.g. 96°F).
When the temperature drops to 2°F below the set temperature, the heater will turn
on until the temperature is 2°F above the set temperature.
In addition to setting the desired water temperature, these two buttons are also used
to change the filter cycles. More information on this is contained in the section on
“
.”
The Heat Indicator Light, located between the UP and DOWN Arrow Buttons, will light up
while the heater is on and flash when there is a call for heat and the heater has not yet been
activated.
Jets 1 Button
JETS 1 Button: Press the button once to turn on Pump 1 to Low Speed. A second
press will turn it to High Speed. A third press will typically turn the pump off, unless
the pump has been automatically activated during a heating cycle – in which case a
third press will return the pump to Low Speed. A built-in timer will shut the pump off
after 20 minutes of operation unless done so manually. The Jets 1 Indicator light will
be lit next to the Jets 1 Button while the pump is running.
Pump 1 provides low or high volume water flow to both the Swim Jets and
HydroTherapy Jets on the AquaFit and AquaPro. The Diverter Valve controls
which set of jets gets the water, and how much is provided. The AquaFit Dual
Temp has separate pumps for the Swim Jets and the HydroTherapy Jets.
press will turn it to High Speed. A third press will typically turn the pump off, unless
the pump has been automatically activated during a heating cycle – in which case a
third press will return the pump to Low Speed. A built-in timer will shut the pump off
after 20 minutes of operation unless done so manually. The Jets 1 Indicator light will
be lit next to the Jets 1 Button while the pump is running.
Pump 1 provides low or high volume water flow to both the Swim Jets and
HydroTherapy Jets on the AquaFit and AquaPro. The Diverter Valve controls
which set of jets gets the water, and how much is provided. The AquaFit Dual
Temp has separate pumps for the Swim Jets and the HydroTherapy Jets.
Pump 1 also runs on low speed during all filter and heating cycles. If the system is in a filter
cycle, the indicator light for JETS 1 will be on. If you manually press the JETS 1 button, this
specific filter cycle will be disabled.
cycle, the indicator light for JETS 1 will be on. If you manually press the JETS 1 button, this
specific filter cycle will be disabled.
11