Dimension One Spas 2003 Manual De Usuario
Aquatic Fitness System
2003 Owner’s Manual
Warranty Service Information
Your Aquatic Fitness System warranty gives you specific coverage. Be sure to read the enclosed warranty
sheet carefully.
The warranty does not cover problems arising from misuse, abuse, or neglect, and it does not cover problems
caused by improper installation or “perceived” problems caused by failure to read the Aquatic Fitness
System Owner’s Manual. A service charge will be made if a service call is made for any of the following:
sheet carefully.
The warranty does not cover problems arising from misuse, abuse, or neglect, and it does not cover problems
caused by improper installation or “perceived” problems caused by failure to read the Aquatic Fitness
System Owner’s Manual. A service charge will be made if a service call is made for any of the following:
1. Equipment failure due to improper/inadequate electrical service. All systems require dedicated
circuits as described in this manual. Low voltage can cause equipment failure and seriously shorten
equipment life. It is the owner’s responsibility to ensure proper electrical service is available.
equipment life. It is the owner’s responsibility to ensure proper electrical service is available.
2. Failure
of
Aquatic Fitness System to reach desired temperature because the set temperature is
not turned up high enough. Maximum thermostat setting is approximately 104° F (40° C).
3. Burned
out
Aquatic Fitness System light. Bulbs are not covered.
4. Aquatic Fitness System water chemistry is the responsibility of the Aquatic Fitness System
owner. Cloudy, dirty or chemically unbalanced water and cleaning of the filters are also the
responsibility of the Aquatic Fitness System owner.
responsibility of the Aquatic Fitness System owner.
5. Aquatic Fitness System shell or equipment damage caused by improper water maintenance.
Serious damage can be caused if your Aquatic Fitness System water is not maintained carefully
and correctly.
and correctly.
6. Poor jet action because the jet Selector valve is in the middle position. For full performance, turn the
jet Selector valve to either the full clockwise or full counterclockwise position.
Do not block the air intakes.
The air intakes for the HydroTherapy Jets are located in the
equipment compartment.
The air intakes for the HydroTherapy Jets are located in the
equipment compartment.
For the Swim jets they are built into the lower portion of the Air Selector
Switches, below the shell.
Proper airflow is required for proper operation. Malfunctions resulting from blocked air
intakes are not covered under warranty.
intakes are not covered under warranty.
31