Impex MXM-5 Manual De Usuario

STEP 1     (See Diagram 1) 
 
A.)  NOTE: Do not tighten the Nuts and Bolts until instructed to do so. 
B.)  Connect the Left & Right Base Frames (#17 & #18) by a Cross Brace (#20) in the mid-

span. Secure each end of the Cross Brace with two M10 x 2 ½” Carriage Bolts (#92), one 
4 3/8” x 1 ¾” Bracket (#46), two Ø ¾” Washers (#82), and two M10 Aircraft Nuts (#99). 

C.)  Attach a Front Vertical Beam (#16) to the Left Base Frame (#17). Secure it with two M10 x 

2 ¾” Carriage Bolts (#93), one 4 ¾” x 2” Bracket (#47), two Ø ¾” Washers (#82), and two 
M10 Aircraft Nuts (#99). Repeat the same procedure to install the other side. 

D.)  Attach the Front Top Beam (#32) to the two Front Vertical Beams. Secure each end with 

one M10 x 2 ½” Allen Bolt (#89), 4” x 2” Bracket (#45), and Ø ¾” Washer (#82) into the top 
hole.  Secure the bottom hole with one M10 x 2 ¾” Carriage Bolt (#93), Ø ¾” Washer 
(#82), and M10 Aircraft Nut (#99). 

E.)  Insert a Guide Rod (#19) into the hole on the Left Base Frame (#17). Secure it with one 

M10 x 1” Allen Bolt (#85) and 

∅

 ¾” Washer (#82) at the bottom. 

F.)  Slide a Lower Safety Stop Frame (#42) and a Safety Stop Frame (#37) onto the Guide 

Rod (#19). 

G.) Secure the top of the Guide Rod with one M10 x 1” Allen Bolt (#85) and 

∅

 ¾” Washer 

(#82). 

H.)  Attach a Safety Hook (#43) to the Lower Safety Stop Frame (#42).  Secure it with one M10 

x 1” Allen Bolt (#85), two 

∅

 ¾” Washers (#82), and one M10 Aircraft Nut (#99). 

I.)  Attach the Safety Hook to the selected hole on the Front Vertical Beam. 
J.)  Repeat procedures E through I above to install the other side.