Impex WM-348.1 Manual De Usuario

A.)  Attach a 

∅

 ¾” Washer (#3) onto a M10 x 6 ¼” Hex Bolt (#54).  Insert the Bolt through 

the Butterfly (#17).  Place a M10 Regular Nut (#57) onto the Bolt. Then insert the Bolt 
through the hole on the Rear Upright Beam (#1). Secure the Bolt with a Lock Knob (#8) 
behind the Upright Beam.  Repeat the same step to install the other Butterfly. 

B.)  Attach the Right Butterfly Handle (#56) to the Right Butterfly (#17). Secure it with a M10 

x 2 ½” Carriage Bolt (#16), 

∅

 ¾” Washer (#3), and M10 Aircraft Nut (#4). Repeat the 

same step to install the other side. 

C.)  Attach the Leg Developer (#38) onto the bracket on the Front Stabilizer (#42).  Secure it 

with a Hex Socket Axle (#44) and Hex Socket Screw (#45). 

D.)  Insert two Foam Roll Tubes (#39) halfway through the hole on the Leg Developer (#38). 

Push four Foam Rolls (#37) onto the tube from both sides. 

E.)  Place three Spring Clips (#34) onto the post on the Leg Developer and Butterfly.