Chief Manufacturing LVS1U / LVSXU Manual De Usuario
LVS1U / LVSXU
Installation Instructions
8
STRUT CHANNEL REQUIREMENTS (LVSXU)
IMPORTANT ! : Strut channel must be made of steel
with a minimum yield strength of 33ksi (230MPa), and
meeting the profile and dimension requirements outlined.
with a minimum yield strength of 33ksi (230MPa), and
meeting the profile and dimension requirements outlined.
Table 1: Strut Channel Dimension Requirements
Figure 2
Figure 3
STEEL THICKNESS
DIMENSION (See Figure 2)
14 ga [0.075"] (2.5mm)
K = 13/16" (21mm)
12 ga [0.104"] (3mm)
13/16" (21mm) < K < 3-1/4" (83mm)
14 ga or 12 ga
L (minimum) = 1/4" (6mm)
L (maximum) = 9/32" (7mm)
7/8"
3/8"
L
K
1-5/8"
IMPORTANT! All dimensions other than "L" and "K"
are nominal requirements.
are nominal requirements.
(10mm)
(22mm)
(41mm)
Strut Channel Profile
UNACCEPTABLE strut channel profiles
Strut channel MUST have
rolled up lips on both sides
of channel.
rolled up lips on both sides
of channel.
Strut channel MUST NOT
have holes or slots on
side walls of channel.
have holes or slots on
side walls of channel.
MOUNTING PATTERN OFFSET CALCULATION
Figure 4
Center line
of display
of display
Center line
of mounting
pattern
of mounting
pattern
Mounting
pattern of
display
pattern of
display
Offset (H)
NOTE: An offset measurement (H) is required if the centerline of the display does not match the centerline of the
display mounting pattern.
1. If display mounting pattern is BELOW display centerline: 8-3/4" - H = Distance from display centerline to rail
display mounting pattern.
1. If display mounting pattern is BELOW display centerline: 8-3/4" - H = Distance from display centerline to rail
2. If display mounting pattern is ABOVE display centerline: 8-3/4" + H = Distance from display centerline to rail
mounting location.
mounting location.