Chief Manufacturing MSP-DCCMD Manual De Usuario

 Model MSP-DCCMD

Installation Instructions

WARNING:  Make sure your cables do not run through 
a pinch point.

1. Connect and secure power/audio/video cables, 

making sure to leave sufficient slack to allow for 
movement of the display.

2. Route power/audio/video cables under each arm, 

allowing sufficient slack in cables for extension and 
avoiding pinch points.

3. Secure cables using two cover plates (160) and four 

screws (90). (see  figure 11)

CAUTION:  Overtightening adjustment will cause 
excessive wear.

1. Using a 3/16” hex wrench (170), slightly tighten or 

loosen lateral tension adjustment bolts.                      
(see  figure 12)

2. Check for desired tension.

3. Repeat Steps 1 and 2 until desired tension is 

obtained.

CAUTION:  Overtightening adjustment screw will 
cause excessive wear.

NOTE:   Remove display to make pitch adjustment.

1. Check adjustment screw on the Centris interface to 

ensure that the screw is tight.  (see  figure 13)

2. If needed, use a 3/16” hex wrench (170) to tighten the 

screw.

90

160

Lateral Tension 
Adjustment Bolts

Pitch Tension
Adjustment Screw