Suburban Mfg 12155-00-DREPAA Manual De Usuario
Form No. 702703 Rev. E August, 2006
21
Owner’s Manual - Oxygen Therapy Door
Tools Required
5/8 in. open-end wrench
Utility knife
Procedure
The hose barb fitting connects the oxygen supply hose to the
nebulizer (Figure 21). To replace the fitting:
The hose barb fitting connects the oxygen supply hose to the
nebulizer (Figure 21). To replace the fitting:
1.
Pull or cut the oxygen supply hose off the fitting.
2.
Hold the white, 4-arm knob on top of the regulator, and
unscrew the barb fitting with a 5/8 in. open-end
wrench.
unscrew the barb fitting with a 5/8 in. open-end
wrench.
Nebulizer Hose Barb
Fitting
P/N 854546
3.
To install the new fitting, hold the knob and tighten the
new fitting with the wrench.
new fitting with the wrench.
4.
Push the oxygen supply hose onto the new fitting.
Note: A small amount of grease on the barbs will ease
assembly.
Note: A small amount of grease on the barbs will ease
assembly.
Figure 21. Nebulizer Barb Fitting
Barb Fitting
5/8 in. Hex
4-arm Knob
Oxygen
Supply Hose