GE 20309 Manual De Usuario

3

Battery Installation

1.  On the back of the remote, push down on the tab and lift the 

cover off.

2.  Match the batteries to the + and - marks inside the battery 

case, then insert 2 AAA Alkaline batteries.

3.  Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons are depressed 
more than 30 seconds. This will save your batteries should your 
remote get stuck in a place where the buttons remain depressed 
(e.g., between the sofa cushions).

Code Saver

You will have up to 10 minutes to change the batteries in your 
remote without losing codes you have programmed. However, do 
not press any buttons until batteries are installed in the remote. If 
buttons are pressed without batteries in the remote, all codes will 
be lost.

Code Setup

The SETUP button is used to setup the remote. You can 
either setup the remote using the code for your brand of 
product, from the code tables (on separate sheet), or you 
can search through the library of codes until you find a 
code that works for your product. Please refer to “Programming 
with Code Search” page 9 for more information on using the code 
search feature to learn how to search through the library of codes 
for your products. NOTE: You can store any kind of code under any 
mode (except TV). I.E. you can store a VCR code under the CBL/SAT 
button, or a DVD code under the VCR button, etc. However, you can 
only store TV codes under the TV button.