Cisco Systems ISA550 Manual De Usuario

Managing Ports

Cisco ISA500 Series Integrated Security Appliances Administration Guide

119

 

-

To release the port from a VLAN, choose a VLAN from the VLAN list and 
click the left arrows. 

NOTE: A LAN port can be assigned to multiple VLANs, but an Access LAN 
port can only be assigned to one VLAN. A DMZ port must be assigned to a 
DMZ network. 

NOTE: You can click the Create VLAN link to create new VLANs. For 
information on configuring VLAN, see 

. 

•

Flow Control: Click On to control the flow on the port, or click Off to disable 
it.

NOTE: Gigabit Ethernet flow control is provided by a PAUSE frame 
mechanism. A congested port sends an XON PAUSE frame, which causes 
the source port to stop sending data until an XOFF PAUSE frame is received. 
For this mechanism to work, flow control must be enabled on the source port 
and the destination port. Even with flow control enabled, the packet drops 
may occur if the receiving port runs out of buffers. 

•

Speed: Choose one of these options: AUTO, 10M, 100M, and 1000M. The 
default is AUTO for all ports. The AUTO option lets the system and network 
determine the optimal port speed.

•

Duplex: Choose either Half or Full based on the port speed setting. The 
default is Full Duplex for all ports. 

-

Full: The port supports transmissions between the device and the client 
in both directions simultaneously.

-

Half: The port supports transmissions between the device and the client 
in only one direction at a time.

Click OK to save your settings.

On the Networking > Ports > Physical Interface page, click Save to apply your 
settings.

Use the Networking > Ports > Port Mirroring page to allow traffic on one port to be 
visible on other ports. This feature is useful for debugging or traffic monitoring. 

The dedicated WAN port (GE1) cannot be set as a destination or monitored port.