Cisco Systems ISA550 Manual De Usuario

Using the Setup Wizard for the Initial Configuration

Cisco ISA500 Series Integrated Security Appliances Administration Guide

38

 

NOTE: You can configure your Cisco.com account credentials on the Device 
Management > Cisco Services & Support > Cisco.com Account page after the 
Setup Wizard is complete. See 

If your Cisco.com account credentials are invalid, click OK to return to the 
Cisco.com Credentials page. Correct your Cisco.com account credentials and 
then click Next to verify them again. 

If your Cisco.com account credentials are valid, proceed to the Upgrade Firmware 
page.

Use the Upgrade Firmware page to enable the device to check for firmware 
updates or to manually upgrade the firmware. 

•

To automatically check for firmware updates, check the box next to Check 
for firmware update when Setup Wizard completes. The security 
appliance will immediately check for firmware updates after the Setup 
Wizard is complete. This feature requires that you have an active WAN 
connection. 

•

To manually upgrade the firmware from a firmware image stored on your PC, 
uncheck the box next to Check for firmware update when Setup Wizard 
completes. Uncheck this box when you do not have an active WAN 
connection and you have already downloaded the latest firmware image 
from Cisco.com to your local PC. 

If you uncheck the box, click Browse to locate and select the firmware image from 
your PC, and then click Upgrade. 

After you click Upgrade, the security appliance starts installing the firmware. This 
process will take several minutes. Do not disconnect the power or reset the 
device. Doing so will cancel the firmware upgrade process and could possibly 
corrupt. The security appliance reboots after the firmware is upgraded. You will 
be redirected to the login screen when the security appliance boots up. 

If you choose to automatically check for firmware updates, click Next.