Cisco Systems ISA550 Manual De Usuario

Backing Up and Restoring a Configuration

Cisco ISA500 Series Integrated Security Appliances Administration Guide

416

 

•

SNMP Read-Write Community: Enter the read-write community used to 
access the SNMP entity.

•

Trap Community: Enter the community that the remote trap receiver host 
receives the traps or notifications sent by the SNMP entity.

•

SNMP Trusted Host: Enter the IP address or domain name of the host 
trusted by the SNMP entity. The trusted host can access the SNMP entity. 
Entering 0.0.0.0 in this field allows any host to access the SNMP entity.

•

Trap Receiver Host: Enter the IP address or domain name of the remote host 
that is used to receive the SNMP traps.

Click Save to apply your settings. 

Use the Device Management > Backup/Restore page to manage your 
configuration.

You can back up your current settings as a configuration file to your local PC or to 
a USB device if applicable. You can later restore the saved configuration if needed. 
You should always back up your configuration whenever you make any 
modifications to the device configuration or performing any firmware updates.

When saving the configuration to a file, the security license and self-signed 
certificates are not saved in the configuration file. 

Click Device Management > Backup/Restore.

To back up the current settings to your local PC, perform the following steps: 

a. In Configuration Backup area, select the Save Configuration to PC radio 

button and click Backup. The Encryption window opens. 

b. If you want to encrypt the configuration, check Encrypt and enter the 

password in the Key field, and then click OK. Locate where you want to save 
the configuration file (configure.bin) and click Save. 

c. If you do not want to encrypt the configuration, click OK. Locate where you 

want to save the configuration file (configure.xml) and click Save.