Cisco Systems ISA550 Manual De Usuario

Using the Setup Wizard for the Initial Configuration

Cisco ISA500 Series Integrated Security Appliances Administration Guide

48

 

-

802.11b/g/n mixed: Choose this mode to allow 802.11b, 802.11g, and 
802.11n clients operating in the 2.4 GHz frequency to connect to the 
access point.

-

802.11n only: Choose this mode if all devices in the wireless network 
can support 802.11n. Only 802.11n clients operating in the 2.4 GHz 
frequency can connect to the access point. 

•

Wireless Channel: Choose a channel from a list of channels or choose Auto 
to let the system determine the optimal channel to use based on the 
environmental noise levels for the available channels.

After you are finished, click Next. 

If you turned the wireless radio off, proceed to 

. If you turned the wireless radio on, use the Intranet WLAN Access page 

to configure the wireless connectivity settings for the SSID called “cisco-data.” 

•

SSID Name: The name of the SSID. 

•

Security Mode: Choose the encryption algorithm for data encryption for this 
SSID and configure the corresponding settings. For complete details, see 

. 

•

VLAN Name: Choose the VLAN to which this SSID is mapped. All traffic from 
the wireless clients that are connected to this SSID will be directed to the 
selected VLAN. For Intranet VLAN access, you must choose a VLAN that is 
mapped to a trusted zone.

NOTE: ISA550W and ISA570W support four SSIDs. To configure the 
wireless connectivity settings for other SSIDs, go to the Wireless > Basic 
Settings page (see 

), or use the Wireless 

Wizard (see 

). 

After you are finished, click Next.