Sima Products SUR-47 Manual De Usuario

SUR-47 User’s Manual   

 

 

 

 

 

 

 

              Specifications 

 

6. Press 

YES  to confirm the selection and save the settings or click EXIT   

to exit. 
Note: When you enter the Manufacture Code and an 'ERROR’ message 
is displayed, it could be for two reasons: 

1.  That code number doesn't exist in the Manufacture Code table 

yet. 

2.  That code number is not in the range of the Manufacture Code 

table reserved for the default device screen 

Selecting a Code Automatically 
1. 

Turn on the target device you want 
to control. 

2. 

Press the device hardware button 
(for example TV). 

3. 

Point the SUR-47 at the target 
device. 
Press the AUTO button. An “OK” 
message displays while the SUR-47 

automatically cycles through the 

codes. Wait for the device to turn 
on and then press the POWER 
button   or AUTO key to stop the 
automatic search. 

 

The last tried code is displayed in the upper right-hand corner. Test this 
code by pressing the POWER button  .  
If it doesn't work, you may need to press the tuning down key 

 and 

try a few of the previously scanned codes. 

4. Press 

YES  to confirm and save the settings or EXIT   to exit. 

Using the Learning Mode 

Follow these instructions to detect and learn a remote control's configuration. 

Before Using the Learning Function 

Before you start using the SUR-47's learning function, please heed the following precautions: 

• 

Not all infrared codes are learnable by the SUR-47. You may need to first collect the codes (see page 17 
for more information) and then email them to Sima Products. New system firmware will be sent to you 
allowing your SUR-47 to learn the codes. 

• 

To change from a device that has already been programmed, delete all of the commands for the first 
device before teaching new ones. For example, to operate the living room TV instead of the bedroom 
TV, delete all commands for the bedroom TV first. Then re-configure the TV device screen for the living 
room TV.   

Code learning does not work with all devices. Select one device screen in advance before using code learning 
mode. All keys except the quick channel keys, sleep, page and macro can be learned.