Craftsman 137.21221 Manual De Usuario

6

7

6

7

and any other conditions that may 

affect its operation. A guard or 

other part that is damaged should 

be properly repaired or replaced.

20. 

THE POWER “OFF”. Do not walk 

away from a running tool until the 

blade comes to a complete stop 

and the tool is unplugged from the 

power source.

21. 

DO NOT OVERREACH. Keep 

proper footing and balance at all 

times.

22. 

MAINTAIN TOOLS WITH CARE. 

Keep tools sharp and clean for best 

and safest performance. Follow 

instructions for lubricating and 

changing accessories.

23. 

WARNING: Dust generated from 

certain materials can be hazardous 

to your health. Always operate saw 

in well-ventilated area and provide 

for proper dust removal.

24.                           People with 

electronic devices, such as 

pacemakers, should consult their 

physician(s) before using this 

product. Operation of electrical 

equipment in close proximity to 

a heart pacemaker could cause 

interference or failure of the 

pacemaker. 

     NOTE: Glasses or goggles not in 

compliance with ANSI Z87.1 could 

seriously injure you when they 

break.

13. 

MASK. Sawing operation produces 

dust.

14.           

SECURE WORK. Use 

clamps or a vise to hold work 

when practical. It is safer 

than using your hand and it 

frees both hands to operate 

the tool.

15. 

POWER SOURCE before servicing, 

and when changing accessories 

such as blades, bits and cutters.

16. 

UNINTENTIONAL STARTING. 

Make sure switch is in the OFF 

position before plugging the tool in.

17. 

ACCESSORIES. Consult 

this Operator’s Manual for 

recommended accessories. The 

use of improper accessories may 

cause risk of injury to yourself or 

others.

18. 

NEVER STAND ON THE TOOL. 

Serious injury could occur if the 

tool is tipped or if the cutting tool is 

unintentionally contacted.

19. 

CHECK FOR DAMAGED PARTS. 

Before further use of the tool, a 

guard or other part that is damaged 

should be carefully checked to 

determine that it will operate 

properly and perform its intended 

function – check for alignment of 

moving parts, binding of moving 

parts, breakage of parts, mounting 



!