Yamaha HTR-5760 Manual De Usuario
21
English
CONNECTIONS
PRE
P
ARA
T
ION
Both AM and FM indoor antennas are included with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
■
Connecting the AM loop antenna
1
Set up the AM loop antenna, then connect it
to the terminals on this unit.
to the terminals on this unit.
2
Press and hold the tab to
insert the AM loop antenna
lead wires into the AM ANT
and GND terminals.
insert the AM loop antenna
lead wires into the AM ANT
and GND terminals.
3
Orient the AM loop antenna
for the best reception.
for the best reception.
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
• A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality, an
outdoor antenna may improve the quality. Consult the nearest
authorized YAMAHA dealer or service center about outdoor
antennas.
outdoor antenna may improve the quality. Consult the nearest
authorized YAMAHA dealer or service center about outdoor
antennas.
■
75-ohm/300-ohm antenna adapter
(U.K. model only)
(U.K. model only)
1
Open the cover of the
included 75-ohm/300-ohm
antenna adapter.
included 75-ohm/300-ohm
antenna adapter.
2
Cut the external sleeve
of the 75-ohm coaxial
cable and prepare it for
connection.
of the 75-ohm coaxial
cable and prepare it for
connection.
3
Cut the lead wire and
remove it.
remove it.
4
Insert the cable
wire into the slot,
and clamp it with
pliers.
wire into the slot,
and clamp it with
pliers.
5
Snap the cover
into place.
into place.
Connecting the antennas
75
Ω
UNBAL.
FM
ANT
AM
ANT
GND
TUNER
AM loop antenna
(included)
Ground (GND terminal)
For maximum safety and minimum
interference, connect the antenna
interference, connect the antenna
GND
terminal to a good earth ground. A good
earth ground is a metal stake driven into
moist earth.
earth ground is a metal stake driven into
moist earth.
Indoor FM antenna
(included)
(included)
Notes
11 (7/16)
8 (5/16)
6 (1/14)
8 (5/16)
6 (1/14)
Unit:
mm (in)
mm (in)
Lead wire
Clamp
Clamp
Insert the wire
into slot.
into slot.
00_HTR-5760_U_EN.book Page 21 Tuesday, February 17, 2004 10:47 AM