Toshiba EO1-32003BE Manual De Usuario
10. PROGRAMMING PROCEDURES
10.15 LON SYSTEM
10-24
10.15 LON SYSTEM
Menu Page: 2
Item No.:
Item No.:
4
The H-9100N scale printer which consists of a master, satellites, and a backup master is connected
with each other by the LON cable to transmit data such as PLU, ING., NUTRI, etc.
with each other by the LON cable to transmit data such as PLU, ING., NUTRI, etc.
ID# 1 is reserved for the master terminal.
ID# 2 is reserved for the backup master terminal or satellite terminal.
ID# 3 to 32 are for satellite terminals.
ID# 2 is reserved for the backup master terminal or satellite terminal.
ID# 3 to 32 are for satellite terminals.
Setting numbers other than the above results in an error.
4
PROG.
ESC.
<MENU>
Page 2
Main
<MENU>
Yes
IN-LINE
↔
OFF-LINE
ENTER
ID #
Set the number of
scales in the system.
ENTER
ID#: 1
No
◇
CHANGE
PLU
NOTES:
1. Before starting the above procedure, press the
1. Before starting the above procedure, press the
key to enter IN-LINE mode.
2. When installing the backup master terminal, set the master scale’s initial status of #9-
1 to 1.
3. Set ID # to all scales in a LON system.
4. When the display power is turned on, the satellite terminal is ready to receive data from
4. When the display power is turned on, the satellite terminal is ready to receive data from
the master terminal.
5. After setting the ID #, turn the power switch OFF and ON again.
<MENU>
Page 2
m
DLL?
n
p
m