Dixon 115 239947 Manual De Usuario

8

Remove plastic end caps from the center bag support 
arm. Fully insert spacer plug into the end of the 
support tube. It may be necessary to tap the spacer 
into place with a hammer or mallet. Replace the 
plastic end cap back over the spacer. The additional 
extension will hold the hood more securely when 
latched.

NOTE: Assistance from another person may ease 
mounting the cover assembly to mower.

Lift and rotate cover to align the cover brackets 

1. 

with support assembly tubes.
Slide the cover down over the support tubes until 

2. 

secure.

Remove center 
end cap

Insert spacer and 
replace cap

ASSEMBLY

Using hardware provided in kit, attach support 

1. 

mount to unit.
Attach hanger bracket to support mount. Do not 

2. 

fully tighten nuts at this time.

Secure rear end of support straps to outside of 

3. 

hanger assembly. Set reinforcement plates to the 
outside of the tank brackets and fasten front end 
of support strap to tank bracket and reinforcment 
plate with round head bolt. Secure front end 
of reinforcement plate to tank bracket with hex 
bolt. Fully secure all mounting hardware. See 
illustration. 
NOTE: Rear guard hole may need to be drilled out 
to 

5

/

16

" if kit hardware is too large.

Hanger Bracket

Support Mount

Support Straps

Reinforcement Plate

Hex Bolt Placement

Round Head 
 Bolt Placement