Polycom 7010 Manual De Usuario

The battery is connected to the handset from factory and must not be removed. 

To replace the battery, please contact your local distributor.

When charging battery for the first time, it is necessary to leave handset in 

charger for 14-16 hours for the battery to be fully charged.
During normal operation, it takes approximately 6 hours to charge the handset 

from fully discharged to its full capacity.

Turning the backlight off reduces 

). 

Place handset in charger. 

For correct charging, be sure the room temperature is between 0°C and 40°C. 

Do not place the handset in direct sunlight. The battery has a built-in heat 

sensor which will stop charging if the battery temperature is too high.
If the handset is turned off when placed in charger, nothing indicates the 

charging. There will be no reaction on incoming calls.
If the handset is turned on when charging, the display shows the blue charging 

icon 

 in the status bar. The charging icon is replaced by the green fully 

charged icon 

, when the battery is fully charged (when handset is removed 

from charger, the charging icon disappears). The handset will not vibrate. Auto 

answer is inactive. The handset reacts normally for incoming calls.
It is necessary to recharge battery when display shows the battery low icon 

, 

or if the handset cannot be turned on. 

The capacity of the battery depends on the use of backlight and talk time.