Polycom I640 Manual De Usuario
SpectraLink Corporation
Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-J.doc
Page 30
beacon interval of 200ms. The third has a signal strength of –56dbm, is configured
on channel 11 with a beacon interval of 100ms.
on channel 11 with a beacon interval of 100ms.
a b 7 b c 8 - 2 8 0 2 1 0 0
2 a e 5 7 8 - 4 8 0 6 2 0 0
2 a e 5 9 6 - 5 6 1 1 1 0 0
A n y D e t l
When the any ESSID mode is selected, the summary display contains the first six
characters of the APs ESSID instead of the beacon interval as in the example below.
characters of the APs ESSID instead of the beacon interval as in the example below.
a b 7 b - 2 8 0 2 A L P H A
2 a e 5 - 4 8 0 6 W S M T E S
2 a e 5 - 5 6 1 1 v o i c e
M y I D D e t l
In detail mode the display would appear as follows. The left/right arrow keys will
move between AP indices.
move between AP indices.
i : b b b b b b s n c h b c n
e e e e e e e e e e e D G H I
r r r r r r r r r r r r r + x x x x
m m m G : g g g g P : p p p p
A n y S m r y
A n y S m r y
Where:
• i = Index of selected AP (value will be from 0 to 3 inclusive)
• bbbbbb = The last three octets of the BSSID for a discovered AP.
• sn = Signal strength in –dbm
• ch = Channel
• i = Index of selected AP (value will be from 0 to 3 inclusive)
• bbbbbb = The last three octets of the BSSID for a discovered AP.
• sn = Signal strength in –dbm
• ch = Channel
• bcn = Beacon interval
• eeeeeeeeeee = ESSID (Up to first 11 characters)
• DGHI = Standards supported
• eeeeeeeeeee = ESSID (Up to first 11 characters)
• DGHI = Standards supported
• rrrrrrrr = Rates supported. Basic rates will have a “b” following the rate.
• + = more rates are supported than those displayed
• xxxx = WMM or UPSD if those QoS methods are supported
• mmm = Security mode
• + = more rates are supported than those displayed
• xxxx = WMM or UPSD if those QoS methods are supported
• mmm = Security mode
• G:gggg = Group key security
• P:pppp = Pairwise key security
• Any/MyID = Softkey to toggle between “single ESSID” and “any ESSID”
• P:pppp = Pairwise key security
• Any/MyID = Softkey to toggle between “single ESSID” and “any ESSID”
modes.
• Detl/Smry = Softkey to toggle between the multiple AP display (summary), and
the single AP display (detail).
Numbers racing across the handset display indicate AP information is being
obtained. A
Waiting
message indicates the system is not configured properly and the
handset cannot find any APs.