Polycom H340 Manual De Usuario

SpectraLink Corporation 

Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone 

 

 

NetLink Telephony Gateway and SpectraLink Radio Protocol 

PN: 72-1065-09-J.doc  

Page 19 

WPA-PSK

  The security features of WPA (Wi-Fi Protected Access) using PSK (pre-

shared key) are available and may be used if supported by the access points in the 

facility. Select either 

Passphrase

 and enter a passphrase between 8 and 63 characters 

in length or 

Direct Entry

 and enter the 256-bit key code. 

WPA2-PSK

  The security features of WPA2 using PSK are available and may be used 

if supported by the access points in the facility. Select either 

Passphrase

 and enter a 

passphrase between 8 and 63 characters in length or 

Direct Entry

 and enter the 256-

bit key code. 

 

Consult the Configuration Guide for the access points installed in your 
facility for information on which of the WPA versions are recommended 
by SpectraLink engineering. Configure the recommended version on the 
AP and select the corresponding option on the Admin menu. 

Regulatory Domain 

The Regulatory Domain will default to North America on the handset display. FCC 
requirements dictate that the menu for changing the domain be available by 

password, which in our case is the 

LINE

 key. To change the domain, press 

LINE

 and 

then enter the digits that represent the site’s domain. Note that both digits must be 
entered.  

01

 - North America 

02

 - Europe (except Spain and France); Japan (channels 1-13) 

04

 - Spain 

05

 - France 

 

As of this writing, Spain and France are adopting the general European 
Regulatory rules. Check with your wireless LAN administrator or supplier 
for which domain to enter in these countries. 

Transmit Power 

Default transmit power is Maximum. It may be set to a lower number if necessary. If 
changed from the default, ensure the Transmit Power setting is the same on all 
handsets and all APs. 

 

Power is limited to 30mW in regulatory domains other than North 
America. 

Diagnostics 
Run Site Survey 

The Site Survey mode is activated by selecting this option. Site survey starts running 
immediately upon selecting this option. See the Diagnostic Tools section for more 
information about Site Survey.  

Diagnostics Mode 

See section 6.2 Diagnostics Mode for a detailed explanation of the Diagnostics Mode 
options. 

Syslog Mode 

See section 6.3 Syslog Mode for a detailed explanation of the Syslog Mode options.