OWI AMP-IC5 Manual De Usuario

Filename:AMPIC5_6 MANUAL

07/18/08

Page 4 of 16

Installation Instructions

Model AMPIC5 / AMPIC6

(UL Listed)

AMPIC5 / AMPIC6 carton includes the following items:

1. One (1) each AMPIC5 or AMPIC6
2. One (1) each UL Listed Power Supply
( IC5/IC6, Tile Bridge, Backcan and Volume Controls are Optional – Sold Separately)

Introduction:

The AMPIC5/AMPIC6 is designed to provide an OWI 5.25” (IC5) or 6.5” (IC6) speaker that is self powered
allowing line input audio that is either balanced or unbalanced to provide the input signal. The power amplifier
provides up to 25 watts of power. It has enough power to allow up to a total of four non-amplified speakers to
be powered by one power amplifier installed on one of the four non-amplified speakers. This would then allow
each speaker to have approximately 5 watts of power. Five watts would be enough power for background
music, voice paging or many voice applications. The AMPIC5/AMPIC6 can also be daisy chained up to a
maximum of 20 connected amplified speakers.

Specifications:

Model Number

AMPIC5 / AMPIC6

Frequency Response

50 Hz to 15 kHz. HF is optimized to enhance frequency
response of the speaker.

THD

<.1%

S/N

>90dB

Input

Configuration

Differential

(noise

reducing)

Minimum Common Mode Rejection

40dB

Maximum Power Output

25 Watts

At load impedance

4 Ohms (2 speakers in parallel or 4 speakers in series parallel)

Minimum Power Supply Voltage

8 Volts

Maximum Supply Voltage

14 Volts

Maximum current protected

Yes

Short Circuit protected

Yes

One wire to ground protected

Yes

Minimum

Load

Impedance

3.2

Ohms

Input

Load

Impedance 10K

Ohms

Plastic

Fire

rated

V-0

Maximum number of Amplifiers on one line

Available Backcan (Sold Separately)

UL Listed and Plenum rated

Available Tile Bridge (Sold Separately)

Support Truss

Warranty

year