ResMed S9 VPAP Tx Manual De Usuario

25

English

If there is a problem, try the following suggestions. If the problem cannot be solved, contact your 

equipment supplier or ResMed. Do not attempt to open the device.

No display
Power is not connected.

Ensure the power cord is connected and the power outlet (if 

available) is on.

The DC plug is partially inserted into 

the back of the device or inserted 

too slowly.

Fully insert the DC plug.

The S9 VPAP Tx and H5i are not 

connected correctly.

Ensure that the S9 VPAP Tx and H5i are securely attached.

Insufficient air delivered from the device
Air filter is dirty.

Replace air filter.

Air tubing is not connected properly.

Check air tubing.

Air tubing is blocked, pinched or 

punctured.

Unblock or free the air tubing. Check the air tubing for 

punctures.

Mask and headgear are not 

positioned correctly.

Adjust position of mask and headgear.

Incorrect air tubing selected.

If you are using the SlimLine, Standard or 3 m air tubing ensure 

that you have the correct air tubing selected via the menu.

The H5i flip lid is not latched 

correctly. 

Close the flip lid ensuring that it clicks into place.

The H5i flip lid seal is not fitted 

correctly.

Make sure the flip lid seal is facing the right way up and fitted 

securely.

Mask vents might be blocked.

Check if you have sufficient venting. Unblock mask vents if 

necessary.

EPAP may be set too low.

Adjust EPAP settings.

There is excessive leak.

Adjust position of mask and headgear.

Pressure rises inappropriately
Talking, coughing or breathing in an 

unusual manner.

Avoid talking with a nasal mask on, and breathe as normally as 

possible.

Mask cushion is buzzing against the 

skin.

Adjust the headgear.

Cushion seated incorrectly causing 

excessive leak.

Adjust headgear or re-fit cushion.

Heated tube fault, replace tube

Device has been left in a hot 

environment.

Allow to cool before re-use. Disconnect the power cord and 

then reconnect it to restart the device.

There is a fault in your ClimateLine 

or ClimateLine

MAX

 heated air tubing.

Discontinue using your ClimateLine or ClimateLine

MAX

 heated 

air tubing and contact your service provider. Use SlimLine, 

Standard or 3 m air tubing in the interim.

High temperature fault, refer to user manual

Device has been left in a hot 

environment.

Allow to cool before re-use. Disconnect the power cord and 

then reconnect it to restart the device.