Coleman 2000002251 Manual De Usuario

STITCH LINE

Read all instructions before set up.

• Select a level site clear of rocks, branches, and other hard or 

sharp objects, to install your shelter.

•  Do not set up your shelter under trees because of potential 

lightning strikes or falling tree limbs in inclement weather.

• Secure with all stakes and guylines provided to prevent property

damage or personal injury.

•  For best results in windy conditions, position narrow end of 

shelter into the wind.

•  Do not drop shelter bag or pole.
•  Do not bounce shelter bag on its end to remove shelter, as these

actions may damage the shock-cord and/or pole ends.

•  THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF 

TWO PEOPLE TO ASSEMBLE.

•  Under no circumstances should this product be used to cover 

automobiles, marine products or similar items.

1. Adjust desired height by sliding 

post upward until push button locks 
into place. Raise each post one 
notch at a time, making sure all four 
posts are level before proceeding to 
the next notch. (Fig. 6 & 7)

NOTE: If installing the screen house
panels to your shelter, skip the following
steps and proceed to “Install the Screen House”on the back page.

1. Select a smooth, level site for your shelter.
2. With two persons standing at diagonal corners of the struc-

ture, grab the leg, and pull out to unfold frame. (Fig. 1)
NOTE: Do not unfold frame completely. This will allow easier 
fit for draping shelter top over frame.

1. Drape shelter top over frame. (Fig. 2)
2. Attach hook & loop fasteners, located on corners of shelter 

top, to four corners of frame post. (Fig. 2A)

3. After fitting each corner of 

shelter top to frame, pull up
sliding mold located on 
upper portion of leg until 
push button snaps into 
place (Fig 3 & 3A).
This will ensure fame is 
fully extended.

4. Secure sides of shelter top to frame

with  large, rectangular, hook & loop 
fasteners provided (2 on each side) 
(Fig. 4). The shelter top has been 
designed to have a tight fit over 
the frame.

5. Secure all remaining hook & loop 

fasteners, located on underside of 
shelter top, to shelter frame. (Fig. 5)

1. Secure shelter by driving nail stakes through 

the holes located on the metal base of each 
frame post. (Fig. 8)

2. Stretch elastic strap on shelter post cover;

then insert metal hook into hole on post. 
Repeat for remaining three posts. (Fig. 9)

3. If shelter is set at shorter heights, secure 

post covers with metal stake through metal
grommet on each. (Fig. 10)
If shelter is set at maximum height, secure post covers with 
metal stake through web strap on end of each. (Fig. 11)

1. To secure guylines, find the guyline plastic slider and look for 

the portion, forming a loop (works just like a slip knot!). 
Extend guylines to ground until taut; then stake through the 
loops to secure. (Fig. 12, 13, & 14). 

Shelter Top 

5010000666

Screen House

5010000667

Sun Wall

5010000668