Siemens XT75 Manual De Usuario
Java User’s Guide
11.2 Emulator
97
s
wm_java_usersguide_v12
Page 74 of 123
2008-02-25
Confidential / Released
needs some seconds to enable the USB port once again after the "IP connection for remote
debugging" is closed.
debugging" is closed.
If necessary, the IP addresses used for the debug connection can also be changed. This is
done in the file "WM_Debug_config.ini". For details, see also the AT^SCFG command and its
“Userware/DebugInterface” parameters described in
done in the file "WM_Debug_config.ini". For details, see also the AT^SCFG command and its
“Userware/DebugInterface” parameters described in
. Please keep in mind, that the IP
address range 10.x.x.x is not supported for the configuration of debugging!
During installation of SMTK some new programs are installed for handling the debugging ses-
sion in conjunction with the IDE. The installation routine of the SMTK doesn't change any con-
figuration of an existing firewall on your PC.
sion in conjunction with the IDE. The installation routine of the SMTK doesn't change any con-
figuration of an existing firewall on your PC.
In the case, that a firewall is installed on your PC and the local configured and used IP connec-
tion (Dial-Up Network connection for debugging) is blocked or disturbed by this firewall, please
configure the firewall or the Dial-Up Network connection manually to accept the new installed
programs and the port or to use another port or contact your local PC administrator for help.
tion (Dial-Up Network connection for debugging) is blocked or disturbed by this firewall, please
configure the firewall or the Dial-Up Network connection manually to accept the new installed
programs and the port or to use another port or contact your local PC administrator for help.