Cisco Systems 4300E Manual De Usuario

This chapter provides instructions for installing and performing the initial setup of the Cisco Video 
Surveillance IP Camera. It also describes how to access the IP camera through a web browser so that you 
can configure it or view video from it, and how to perform other important tasks.

This chapter includes these topics:

This section describes how to install the IP camera. Before installing, review these guidelines:

The IP camera requires a network cable and a connection to a standard 10/100BaseT router or 
switch. To power the IP camera with Power over Ethernet (PoE), a switch must be 802.3af 
compliant.

If you are using the IP camera on a network connection that does not provide PoE, you must use a 
Cisco 12 VDC power adapter (Cisco part number CIVS-PWRPAC-12V) or a third-party 24 VAC 
power adapter.

If you are using an external speaker, microphone, input device, output device, or pan/tilt control 
device, you must configure additional settings after installing and performing the initial set up of the 
IP camera before the external device can fully operate. For detailed information about these settings, 
see 

If you do not connect an external device (speaker, microphone, input, output, or pan/tilt control) 
when you perform the following installation procedure, you can install any of these devices later.

The 4300E and 4500E IP cameras can be placed in a housing that makes the back focus hex screw 
inaccessible. If you are placing the camera in a housing and adjusting the back focus is required, you 
must complete the procedure in the 

 

before you install the camera using the procedure in this section.