Petsafe HBK11-11926 Manual De Usuario

8 

•  (5) Clips
•  (1) Tension  rod

1. Stretch the fabric as tightly as possible 

to the corner post and select a fabric 

wire to cut, allowing 4 inches (10 cm) 

for the tension rod and clips (

6A). 

2. Cut the fabric by holding the fabric 

loosely while you spin one of the 

pickets out.
a.  Undo the knuckle at the top and 

the knuckle at the bottom of the 

same picket (

6B).

b. Unweave that picket by spinning 

it out (

6C). 

 

Wire ends may 

be sharp. 

c.  Install the tension rod (

6D) and 

5 clips (

6E).

Pinching may 

occur during 

fabric installation. 

Work gloves are 

recommended.

4 inches

(10 cm)

Remove this picket

Repeat Steps 5-6 using the second roll of fence fabric. Start again at the other gate post. You will use the 

remaining tension rods and 10 clips to complete these steps.

Beginning at the gate opening, attach a tie wire to every 5th diamond around the top 

(

8A) and every 3rd diamond around the bottom (8B) of the dog kennel. Use any extra 

tie wires around the bottom for extra security.
Note: Attaching tie wires around the bottom is easier if you temporarily raise the bottom of the 

dog kennel onto bricks, blocks of wood, or the box that the dog kennel came in. 
Tip: Zip Ties can be added for extra reinforcement.

Pet may escape or become trapped in loose chain link fabric. Be 

sure that the fabric is stretched tightly and securely. If properly 

stretched, there should not be any slack in the fabric.

6

7

8