Linksys DES-3028/DES-3028P/DES-3052/DES-3052P Manual De Usuario

DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual

config greeting _message

message).

Parameters

default – If the user enters default to the modify banner command, then
the banner will be reset to the original factory banner.
To open the Banner Editor, click Enter  after typing the config
greeting_message  command. Type the information to be displayed on
the banner by using the commands described on the Banner Editor:
Quit without save:        Ctrl+C
Save and quit:              Ctrl+W
Move cursor:                 Left/Right/Up/Down
Delete line:                  Ctrl+D
Erase all setting:           Ctrl+X
Reload original setting: Ctrl+L

Restrictions Only

administrator-level users can issue this command. Other restrictions

include:

• If the “reset/reset config” command is executed, the modified

banner will remain modified. However, the “reset system”
command will reset the modified banner to the original factory
banner.

• The capacity of the banner is 6*80. 6 Lines and 80 characters per

line.

• Ctrl+W will only save the modified banner in the DRAM. Users

need to type the “save” command to save it into FLASH.

• Only valid in threshold level.

Example usage:

To modify the banner to read “Say goodnight, Gracie”:

DES-3028P:4# config greeting_message
Command: config greeting_message

Greeting Messages Editor
================================================================================
Say Goodnight, Gracie
                              DGS-3028P Fast Ethernet Switch
                                    Command Line Interface

                                    Firmware: Build 1.00-B22
       Copyright(C) 2006-2009D-Link Corporation. All rights reserved.
================================================================================

<Function Key>                        <Control Key>
Ctrl+C Quit without save      left/right/
Ctrl+W Save and quit           up/down Move cursor
                                                    Ctrl+D     Delete line
                                                    Ctrl+X      Erase all setting
                                                    Ctrl+L     Reload original setting
--------------------------------------------------------------------------------------------------------------------------------------------