Hitachi VT-M272A Manual De Usuario
Getting Started (Initial Setup)
29
Once channels are preset, you can use the up and down CHANNEL buttons to move
through the active channels or you can press the number buttons to move quickly
between channels that are far apart.
through the active channels or you can press the number buttons to move quickly
between channels that are far apart.
Removing Channels
You may not want to keep all the stations the auto-programmer selects, since you may
prefer to have only a few favorite channels in the tuner's memory or you may want to
delete from memory a weak or unused channel that the tuner picked up.
• Erased channels cannot be selected by the up and down CHANNEL SELECT buttons
but can still be selected by using the numbered buttons 0 to 9 and 100/ENT.
You may not want to keep all the stations the auto-programmer selects, since you may
prefer to have only a few favorite channels in the tuner's memory or you may want to
delete from memory a weak or unused channel that the tuner picked up.
• Erased channels cannot be selected by the up and down CHANNEL SELECT buttons
but can still be selected by using the numbered buttons 0 to 9 and 100/ENT.
Adding Channels
Occasionally the auto-programming may skip an active channel because the antenna
was pointed in the wrong direction or the channel had a weak signal or was "off the air"
at the time of programming or you may change your mind about a channel you removed
from memory.
Occasionally the auto-programming may skip an active channel because the antenna
was pointed in the wrong direction or the channel had a weak signal or was "off the air"
at the time of programming or you may change your mind about a channel you removed
from memory.
To Add or Erase Channels
• Press GUIDE, then press 5 to bring up the Initial Setup screen. Item 3 lets you add or
delete channels. Use the number buttons to enter the channel you want to change, then
press STOP to delete it or press PLAY to add it.
• Press GUIDE, then press 5 to bring up the Initial Setup screen. Item 3 lets you add or
delete channels. Use the number buttons to enter the channel you want to change, then
press STOP to delete it or press PLAY to add it.
Caution After a Power Failure
If a power failure lasting for more than 30 minutes occurs, reset the clock and perform the
"AUTO CHANNEL SETTING" found in the "INITIAL SET-UP" menu.
If a power failure lasting for more than 30 minutes occurs, reset the clock and perform the
"AUTO CHANNEL SETTING" found in the "INITIAL SET-UP" menu.