Intel DH57JG LGA-1156 mini-ITX DDR3 1333/1066 MHz 8GB BOXDH57JG Manual De Usuario
Los códigos de productos
BOXDH57JG
Technical Reference
53
2.5
Electrical Considerations
2.5.1
Power Supply Considerations
CAUTION
The +5 V standby line from the power supply must be capable of providing adequate
+5 V standby current. Failure to do so can damage the power supply. The total
amount of standby current required depends on the wake devices supported and
manufacturing options.
Additional power required will depend on configurations chosen by the integrator.
The power supply must comply with the indicated parameters of the ATX form factor
specification.
• The potential relation between 3.3 VDC and +5 VDC power rails
• The current capability of the +5 VSB line
• All timing parameters
• All voltage tolerances
+5 V standby current. Failure to do so can damage the power supply. The total
amount of standby current required depends on the wake devices supported and
manufacturing options.
Additional power required will depend on configurations chosen by the integrator.
The power supply must comply with the indicated parameters of the ATX form factor
specification.
• The potential relation between 3.3 VDC and +5 VDC power rails
• The current capability of the +5 VSB line
• All timing parameters
• All voltage tolerances
For example, for a system consisting of a supported 87 W TDP processor (see
Section 1.4 on page 14 for information on supported processors), up to 8 GB DDR3
memory, integrated graphics, one hard disk drive, one optical drive, and all board
peripherals enabled, the minimum recommended power supply is about 260 W with
current ratings as listed in Table 28.
Section 1.4 on page 14 for information on supported processors), up to 8 GB DDR3
memory, integrated graphics, one hard disk drive, one optical drive, and all board
peripherals enabled, the minimum recommended power supply is about 260 W with
current ratings as listed in Table 28.
Table 28. Recommended Power Supply Current Values
Output Voltage
3.3 V
5 V
12 V1
12 V2
-12 V
5 VSB
Current
12 A
18 A
14 A
16 A
0.3 A
2 A
NOTE
+12 V1 denotes the 12 V rail at the 2 x 12 power connector.
+12 V2 denotes the 12 V rail at the 2 x 2 power connector.
For information about
Refer to
Selecting an appropriate power supply