Tyco Electronics M7100IP Manual De Usuario

 

the 

n keylight remains lit. If the site does not receive the message properly, a low-pitched tone 

sounds and the 

n keylight will blink. 

If an incorrect message text was selected or the incorrect number button was pressed, the message 
text can be changed during the pre-programmed time-out period by pressing another number 

button. The message text selection can also be cancelled by pressing the 

c button prior to the 

time-out period. 

To view the currently selected message text after it has been transmitted, press the 

n button 

and then the 

c button prior to the time-out period. If the message text was not sent 

successfully to the site, the text associated with the message will flash in the display. 

This feature permits the radio user to scan a pre-programmed conventional system and channel as a Priority 
1 (P1) channel while the radio is selected for EDACS trunked system. If activity is detected on the 
conventional P1 channel, the radio will unmute and remain on this conventional channel for the 
programmable hang time. 

The radio must be pre-programmed to designate a button for scan ON/OFF operation. 

Dynamic regroup operation permits multiple talk groups (up to eight) to be added to a radio via the 
Communications Systems Director (CSD). The radio must be pre-programmed to respond to regrouping. 
Dynamic regrouping will not be activated in a radio until an activation message is sent by the system 
manager. Each radio that receives and acknowledges regrouping instructions is successfully regrouped. 

Pressing and holding the 

C (Scan Model) or c (System Model) button for 2.5 seconds toggles 

the user into and out of the dynamic regroup group set. A double beep will sound for entry or exit. The 
display will indicate REGR_0x where "x" is a digit of 1 to 8 indicating the group when dynamic regroup 
has been enabled by the user. If the radio is in dynamic regroup and the user selects a group that has not 
been regrouped, the display will show NO ENTRY. The radio will be prevented from transmitting and 
receiving calls in this condition except for scanned groups. 

If the pre-programmed group set on the currently selected system contains an EMER/HOME 
group and the radio is in dynamic regroup, the radio will exit dynamic regroup and declare the 
emergency on the HOME group. If no EMER/HOME group is present, the radio will declare the 
emergency on the currently selected dynamic regroup group. 

The Radio TextLink option provides a simple means of exchanging text messages. This section describes 
how to send and receive text messages if the Radio TextLink feature is enabled.  

1.  Select SEND MSG with the 

M and scroll through the list of pre-defined messages using 

, or .. 

2.  Select the desired message with the 

M key.