AEG 56609 Manual De Usuario

Descargar
Página de 36
Safety instructions
5
Safety instructions
The safety of AEG electrical appliances complies with the established 
technical principles and statutory equipment safety regulations. 
Nevertheless, as manufacturer we have to draw your attention to the 
following safety instructions.
General safety
• Repairs of the dryer may be carried out only by trained personnel. 
Incompetently carried out repairs can entail considerable hazards for 
the user. Please get in touch with our customer service or with an 
authorised AEG dealer when repair is necessary.
• Before commencing operation please make sure that the nominal 
voltage and type of supply specified on the type plate of the 
appliance correspond to the actual nominal voltage and supply type 
at the place of utilisation. The fuse rating is also specified on the type 
plate.
• Never operate the dryer when the mains cable is damaged or when 
the operator control mask, work plate or base shrouding are damaged 
such that there is direct access to the interior of the appliance.
• Switch-off the dryer before carrying out any cleaning, care and 
maintenance tasks! You are quite safe if you disconnect the mains 
plug from the power outlet or – if the electrical connection is 
permanent – if you switch-off the circuit breaker in the fusebox or 
screw the fuse cartridge right out of its holder.
• Never pull on the cable to disconnect the mains plug from the power 
outlet. Always grasp and pull-out the plug.
• Don’t lean on the opened door; this could make the appliance fall 
over.
• Don’t use a water jet to spray-down the appliance. Danger of electric 
shock!
• The covering hood for the filament lamp bulb for drum illumination 
must be screwed-on.
• If you interrupt the drying process to take out laundry, bear in mind 
that the laundry and the drum could be hot.
• Adaptors and extension cables must not be used. There is risk of fire 
because of overheating!