Samsung DV42H5400EF Manual De Usuario

3

In normal mode, press Drylevel  Time  Temp  Time in less than 2 seconds to enter the 

display mode.

To change the mode, use the cycle selector dial.

Display Mode 1 : Main micom version

Display Mode 2 : display micom version

Display Mode 3 : touch module version

Display Mode 4 : option value

Display Mode 5 : Temperature data

Display Mode 6 : Average temperature data for 1 minute

Display Mode 7 : Temperature data for detecting vent clog up

Display Mode 8 : Average touch sensor data for 1 minute

Display Mode 9 : cycle count

This allows service personnel to check if the dryer is installed properly.
To enter this mode
Turn on the product, and press and hold the Adjust Time Up + Temp key for 7 seconds.
A message of “SC” appears on the display.
1.  Checking the touch sensor
 

Enter the Smart Install mode, and open the door. The state of the touch sensor appears on the 

display.

0 : Touch sensor open

1 : Touch sensor short

Put a wet cloth on the touch sensor to display "1". Releasing it displays "0".

2.  Checking the motor and the heater
 

After checking the touch sensor is complete, press the Start button to enter the checking 

mode. When the checking is complete, the results appear on the display.

OK : Both motor and heater work normally

HE : Motor or heater doesn't work normally

 

To exit the Smart Install mode, turn off the product.

Error Recall Mode
The Error Recall mode reminds users of the latest error that appeared.
Press and hold both the Wrinkle prevent + Dry Level keys for more than 7 seconds to enter this mode.
In the Error Recall mode, the most recent error that occurred is displayed. If there is no recent error, 
nothing is displayed.

To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before 
servicing, unless testing requires power.

Technical_information-03382A_EN_131209.indd   3

2013-12-09   �� 5:37:31